
Requires 6 AAA batteries to operate fan (not included
Before attempting assembly, please read through the assembly instructions
to familiarize yourself with all the parts and assembly steps. Please refer to the
Parts Identifi er below and be sure that all parts have been included.
Please keep your instructions.
Open the carton of your new hockey game near where your
game will be played. Select a clear level fl oor
. Carefully cut or tear the carton corners so that
bottom carton becomes a fl at working
surface area. It is recommended to
hand screw driver instead of electric to avoid over stripping.
Install batteries to correct polarity.
Do not mix diferent types of new or used batteries.
Installation by adult required.
Dispose of batteries responsibly.
Do not dispose of in fi re.
Attach the two Goal Boxes (#2) to the hockey end aprons using
four of Washer Head Screws (#4) per Goal Box. See FIG.1.
Peel the backing off the Felt Pad (#7) and attach to
the Pusher (#5) as shown in Fig 1A.
the batteries turn the switch on.
ICONICS™ is a registered trademark of DMI Sports.
Fort Washington, PA 19067