DOD MEATBOX User manual

1 2
3 4
5
6
8
7
1. OCTAVE - adjusts the amount of low octave being added to the signal.
2. OUTPUT - adjusts the overall output level of the eect.
3. SUB - adjusts the amount of synthesized sub harmonic eect is added to the signal.
4. LOW - adjusts the low frequency content of the overall eect.
WARNING: Start with the OUTPUT and LOW controls at minimum and gradually increase
their level to avoid possible speaker damage.
5. INPUT - connect your instrument here.
6. FOOTSWITCH - turns the eect on and o.
7. LED - turns on when the eect is enabled.
8. OUTPUT - connect to the next pedal input or to the input of your amplier. This output
allows you to route a dry unprocessed signal (Ring) and processed signal (Tip)
to an amplier and other eects simultaneously via TRS ‘Y’ cable.
Tip = Octave+Sub
Ring = Dry
Sleeve = Ground

USING MEATBOX:
Most bassists will favor placing the Meatbox at the beginning of
their chain of eects, so start with that placement. Guitarists may
nd it better to add after distortion eects or near the end of the
eect chain.
A typical eects signal chain will consist of Distortion eects rst
then Modulation eects (Chorus, Flanger, Phaser, Tremolo, etc...)
next and then nally Time based eects (Delay and Reverb).
This being said you may wish to experiment with dierent eect
placements.
SPECIFICATIONS:
Input 1/4”TS Unbalanced - 470 kΩ
Output 1/4”TRS Unbalanced - 100 Ω
Current Draw 20 mA
Bypass True Bypass
Power 9VDC alkaline battery (not included)
HARMAN PS0913DC power adapter (optional)
Warranty 1 Year
DOD
10653 River Front Parkway
South Jordan, UT 84095
USA
801-566-8800 Rev A - 6/15