Connect the foot pump to
the shower bag through
the air inlet. Then connect
the water hose to the water
outlet of the shower bag at
its bottom.
WARNINGS
OPERATIONS
Please use the shower bag on flat ground and keep it away from high temperature and
rough ground.
1.
Please grab the strap and hold the fully-filled shower bag from the bottom simultaneously
when you try to move the shower bag around, in case the strap will break due to overweight.
2.
Please drain the water in the shower bag before storage. Otherwise, the shower bag may
leak water.
3.
Do not fill the shower bag with hot water that is over 122°F. Keep the shower bag away from
sharp objects.
4.
If the shower bag is overinflated, water may keep flowing from the lid on the top of the foot
pump. Please do not worry and close the lid to prevent water from flowing out.
5.
1. Prior to the use, please
open the lid of the foot
pump on the top and shut
off the lid at its bottom.
2. Open the lid of water inlet
at the top of the shower
bag, fill the bag with water
(around 50%-75%), and
close the lid.
3.
Step on the foot pump and
pump air into the shower
bag until the shower bag is
fully inflated.
4. Press the nozzle gently to
spray water.
5. If water pressure goes down,
please pump the shower bag
again. Meanwhile, please
check the remaining water
capacity via the water level
window.
6.
Connect the foot pump to
the shower bag through
the air inlet. Then connect
the water hose to the water
outlet of the shower bag at
its bottom.
WARNINGS
OPERATIONS
Please use the shower bag on flat ground and keep it away from high temperature and
rough ground.
1.
Please grab the strap and hold the fully-filled shower bag from the bottom simultaneously
when you try to move the shower bag around, in case the strap will break due to overweight.
2.
Please drain the water in the shower bag before storage. Otherwise, the shower bag may
leak water.
3.
Do not fill the shower bag with hot water that is over 122°F. Keep the shower bag away from
sharp objects.
4.
If the shower bag is overinflated, water may keep flowing from the lid on the top of the foot
pump. Please do not worry and close the lid to prevent water from flowing out.
5.
1. Prior to the use, please
open the lid of the foot
pump on the top and shut
off the lid at its bottom.
2. Open the lid of water inlet
at the top of the shower
bag, fill the bag with water
(around 50%-75%), and
close the lid.
3.
Step on the foot pump and
pump air into the shower
bag until the shower bag is
fully inflated.
4. Press the nozzle gently to
spray water.
5. If water pressure goes down,
please pump the shower bag
again. Meanwhile, please
check the remaining water
capacity via the water level
window.
6.
