DR. SAFE CCH004 User manual

Assembly Instructions
5CHL0
DR. SAFE
“For A safe Environment!”
CYLINDER STORAGE CABINET
MODEL: CCH004
A
B
C
D
E
F
.
29"
.
.
Back panel
Base
Door
Side panel
Shelf
Top panel
1 PC
1 PC
1 PC
2 PCS
1 PC
1 PC
G
H
1/4"× 3/4"
Bolt and nut
Washer
26 Pairs
26 PCS
*Caution: Two person assembly is recommended. B
Flat edge of rail facing upward
1. In an open assembly area free of obstructions, place the base (B) upright as
shown. Assemble each side panel (D) by hand-tightening the bolts, washers, and
nuts provided (G & H). Side panels should be mounted such that the flat part of the
shelf support rail will face upward.
D
2. Assemble the top panel (F) to the side panels (D). Hand-tighten the bolts,
washers, and nuts provided (G & H). Ensure the unit is square and firmly tighten
the bolts connecting the side panels to the base. Tighten the bolts connecting the
side panels to the top panel. Set unit upright.
F
A
Flat edge of rail facing upward
3. Connect the back panel (A) to side panels (D) using bolts, washers, and nuts
provided (G & H). Ensure the unit remains square and firmly tighten the nuts.
Note: out of square assembly will prevent the door from closing properly.

Assembly Instructions
5CHL0
DR. SAFE
“For A safe Environment!”
CYLINDER STORAGE CABINET
MODEL: CCH004
4. Attach the door (C) to the assembly using bolts, washers, and nuts provided (G & H).
Note: that the hinges are configured for a left-hand swing, but mounting hardware
can be removed and reversed to a right-hand swing if desired. Hand-tighten nuts,
adjust the door's position such that an even gap is maintained on all sides. Then C
firmly tighten nuts.
E
5. Insert the shelf (E) and bolt it to the shelf support rail using bolts, washers,
and nuts provided (G & H).
G
6. Finished.
Stock
Number
Finish
Dimension(In.)
W × D × H
Capacity
CCH004
Powder Coated
31 × 30 × 35
4 Horizontal
FLAMMABLE
MATERIALS
DANGER