DRAENERT 1515 TADAO User manual

MONTAGE
ASSEMBLY
1515 TADAO
OPERATION

ASSEMBLY
1515 TADAO
CONTENT OF DELIVERY
(remains with the customer)
- 1 pedestal
- 1 inner table top
- 1 outer table ring
- 2 plastic guides
- 1 compression spring
- 77 precision balls
- 6 cylinder head screws
- grease
- material information
- care product
3 I Every precaution must be taken in the next step, that
the outer table ring does not collide with the inner top
(there is only a gap of 1 mm!) Lift the outer table top ring
carefully over the inner table top plate and place it on the
pedestal, that the 6 metal support parts are aligned with
the 6 holes in the support arms of the pedestal.
The markings on the metal support parts and on the
6 holes on the arms must match!
1 I Place all precision balls into the groove of the
turned center part and apply slightly some grease
on the balls.
Put one of the both plastic guides with thicker
socket ahead into the central hole and insert the
COMPRESSION SPRING (A).
2 I NOTICE The table has been set in the factory and
is marked with marking points on the table tops and
at the base. Lift the inner table top carefully and evenly
and thread the ROD (B) of the glued-on support part
into the cylinder or socket of the pedestal.
PERSONS REQUIRED FOR ASSEMBLY: 3 PERSONS
Please unpack all parts carefully and position the pedestal of the table in its final place.
A
B

ASSEMBLY
4 I Screw-in the 6 cylinder head screws into the outer
holes of the braces from below and fasten the metal
support parts in this way. Do not over-tighten the
screws, hand-tight is quite sufficient.
NOTICE While tightening the screws, pay attention to
the table top. The table top shall under no circumstances
be deformed or lifted in the center.
The table is now ready assembled.
Now the inner table top can be rotated by 360°.
CARE
The table is maintenance-free. For the care of the different stone types please see the
according material information.
INSTRUCTIONS FOR MOVING THE TABLE
For moving the completely assembled table, never carry it on the projecting edge of the
table top. The stone tops may break. Please use wooden bars, which must be set under the
support arms of the table top. But it is recommendable to disassemble the table.
REMOVAL
For a removal of the table, the table tops must be disassembled and transported well protected
and packed. The table tops must be transported separately and in the upright position.
A horizontal transport inevitably leads to a breakage of the table tops!
OPERATION

DRAENERT GMBH
STEIGWIESEN 3
88090 IMMENSTAAD / BODENSEE
GERMANY
FON +49 (0) 7545 – 2080
[email protected]
www.draenert.de STAND 1/2019
BEDIENUNG