Draper IntelliFlex User manual

Installation Instructions
™Wall Switch by Draper
Copyright ©2007 Draper Inc. Form IntelliFlex-WallSwitch_Inst07 Printed in U.S.A.
If you encounter any difficulty installing or servicing your IntelliFlex Switch, call your
dealer or Draper, Inc., Spiceland, Indiana, [phone]; or fax [phone].
RF “Bus”Wall Switch
“Bus”Wall Switch
Dry Contact Wall Switch
Please Note: For programming
instructions, please see page 2.
"Eye"
Jack
Program
Button
Program
Button
"Eye"
Jack
(Switch Front/
Button Map)
(Switch Back/
Board Map)
Please Note: This drawing indicates all
possible connection and button loca-
tions. Your switch may not have the same
number of buttons or connections, but
their locations will be consistent with
these "maps."
Compare your switch with these dia-
grams, and wire the buttons and connec-
tions on your switch accordingly.
Dry Contact switch is not programmable.
Dry Contact switch can be connected to
a Bus via a PSI60.
3
5
7
4
6
8
COM
COM
COM
5
COM
6
7
COM
8
3
COM
4

Page 2 of 2
IntelliFlex Wall Switch by Draper
www.draperinc.com
[phone]
Programming IntelliFlex Switch
Dry Contact: Does not have a Bus connection, and is not programmable. It is
somewhat configurable, based on how it is connected—it must be connected
directly to each device it is controlling. Can be connected to a Bus via PSI60.
RF: Battery operated. Programming the RF switch requires physical contact with
the back of the switch, and allows programming of which button sends which
command, along with other options. When replacing batteries, test switch to make
sure it works. If not, remove batteries, wait a few seconds, then re-insert them.
The switch may operate with low batteries, but programming may not work.
Programming Switch “Locally” Using IR Transmitter
Press programming button on back of switch. Red LED on back of switch will
come on, indicating it is in program mode. This method uses the eye on the back
of the switch, so youmust use an IR transmitter for programming, and youmust
have access to the back of the switch. Bus commands are ignored during this
process.
To set button “#” on switch to send a new “command”:
➀ Press programming mode button on back of switch (red LED appears).
➁ Press and release the switch button youwant to program. The LED will change
from red to green.
➂ Press the command on the IR transmitter youwant to be assigned at the
button youjust selected (pressing “Stop” at this point will assign the stop
command to the selected button).
➃ The LED will go back to red and youare back in program mode; e.g. to
program the top left button to send Close 7: press the top left button, then
press Close 7 on the IR transmitter.
Clear button “#”:
Press programming mode button on back of switch (red LED will appear).
Press OPEN “#” on the IR transmitter, where “#” is the switch button number to
clear. The red LED will blink off then back on, and youare back in program mode.
Reset to factory default:
Press programming mode button on back of switch(red LED will appear).
Press CLOSE ALL on IR transmitter. The red LED will blink off then back on, and
youare back in program mode. If this is an RF switch, the radio address will not
change.
Change RF switch’s radio address:
Press programming mode button on back of switch (red LED will appear).
Press Open 13 on the IR transmitter. Red LED will blink off then back on, and the
radio address will be changed.
Exit programming mode:
Press STOP on the IR transmitter, and LED will turn off; or, LED will turn off
automatically after 10 seconds of no IR commands or buttons pushed.
Please Note
The eye on the back of the switch is only for programming and will not act as a
receiving eye.