DreameTech Dreame P10 User manual

P2013A
A01
2021/08/19
（美版）说明书
04170500000620
夏东波
105g 哑粉纸 彩印 骑马钉装订
140mm*210mm
墙靠距离由 100cm 更改为 102cm
CMYK 四色印刷

Cordless Stick Vacuum
User Manual

User Manual
Manuel d'utilisation
Manual de usuario
1
20
39
EN
FR
ES

1
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE). Failure to follow the warnings
and instructions may result in electric shock, 󽗉re and/or serious injury.
SAVE THESE INSTRUCTIONS
Household use only.
WARNING – To reduce the risk of 󽗉re, electric shock, or injury:
• Do not use outdoors or on wet surfaces.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children,
pets or plants.
• Use only as described in this manual. Use only manufacturer's recommended attachments.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into water, return it to a service center.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around
sharp edges or corners. Do not run appliance over cord. Keep cord away from heated
surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not handle charger, including charger plug, and charger terminals with wet hands
• Do not put any object into openings. Do not use with any opening blocked; keep free of dust,
lint, hair, and anything that may reduce air 󽗊ow.
• Keep hair, loose clothing, 󽗉ngers, and all parts of body away from openings and moving
parts.
• Use extra care when cleaning on stairs.
• Do not use to pick up 󽗊ammable or combustible liquids, such as gasoline, or use in areas
where they may be present.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot
ashes.
• Do not use without dust bin and/or 󽗉lters in place.
• Prevent unintentional starting. Ensure the switch is in the o󽗈-position before connecting to
battery pack, picking up or carrying the appliance. Carrying the appliance with your 󽗉nger
on the switch or energizing appliance that have the switch on invites accidents.
• Disconnect the battery pack from the appliance before making any adjustments, changing
accessories, or storing appliance. Such preventive safety measures reduce the risk of starting
the appliance accidentally.
Safety Information EN

2
Caution:
This device complies with Part 15 of the FCC Rules / Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference. (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modi󽗉cations not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o󽗈 and on, the user is encouraged to try to correct
the interference by one or more of the following.
Direct current
Alternating current~
EN • Recharge only with the charger speci󽗉ed by the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of 󽗉re when used with another battery pack.
• Use appliances only with speci󽗉cally designated battery packs. Use of any other battery
packs may create a risk of injury and 󽗉re.
• When battery pack is not in use, keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects, that can make a connection from one
terminal to another. Shorting the battery terminals together may cause burns or a 󽗉re.
• Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, 󽗊ush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
• Do not use a battery pack or appliance that is damaged or modi󽗉ed. Damaged or modi󽗉ed
batteries may exhibit unpredictable behavior resulting in 󽗉re, explosion or risk of injury.
• Do not expose a battery pack or appliance to 󽗉re or excessive temperature. Exposure to 󽗉re
or temperature above 130° C may cause explosion.
• Follow all charging instructions and do not charge the battery pack or appliance outside of
the temperature range speci󽗉ed in the instructions. Charging improperly or at temperatures
outside of the speci󽗉ed range may damage the battery and increase the risk of 󽗉re.
• Have servicing performed by a quali󽗉ed repair person using only identical replacement
parts. This will ensure that the safety of the product is maintained.
• Do not modify or attempt to repair the appliance or the battery pack except as indicated in
the instructions for use and care.
• Do not use and store in extremely hot or cold environments (below 0℃ /32° F or above
40℃ /104° F). Please charge the cordless vacuum in temperature above 0℃ /32° F and below
40℃ /104° F.

3
Accessories List
Product Overview
Note: The illustrations in this manual are indicative only. The actual product may di󽗈er.
Multi-Brush Bar
2-in-1 Crevice Nozzle Power Adapter
Extension Rod
Attachment Clip
Wall Mount
(Including screws ×2, wall plugs ×2)
EN

4
Component Names
Battery Pack
Release Button
Brushbar Head
Release Button
Extension Rod
Release Button
Extension Rod
Display Screen
Multi-Brush Bar
Dust Bin Release Button
Charging Port
Dust Bin
Product Overview
Antistatic Contact
On/O󽗈 Switch
Release to turn o󽗈
Press to turn on
Attachment Clip
EN

5
Product Overview
Display Screen
Note: If the vacuum is not working properly, the screen display will produce an error
message. Please refer to the troubleshooting section to 󽗉nd your solution.
Electronic Lock
• Press brie󽗊y to enter/exit lock
• Upon locked, press brie󽗊y to switch to
continuous cleaning
Suction Level Button
Press brie󽗊y to switch the suction levels
Status Indicator
• Blue: Normal
• Red: Out of battery/Error
Battery Status Indicator
• Red: Battery Level ＜ 20%
• White: Battery Level ≥ 20%
Suction Level Status
Eco
Med
Turbo
EN

6
Installation
Vacuum and Accessories
Installation Diagram
Click
Click
EN

7
Wall Mount Installation Diagram
The mount should be installed in a cool, dry place near a power outlet. Make sure the
installation area is clear of any pipes such as gas or water lines, and air ducts, electric wires
and cables, or drainage lines.
Connecting the Charging Adapter to the Wall Mount
1. Rotate the clip in the bottom of wall mount 90 degrees counterclockwise to remove it
from the mount.
2. Insert the charging adapter cord into the notch on the clip.
3. Rotate the clip 90 degrees clockwise until it clicks into place.
1. Before installation, measure the wall in the height of 102cm (40.2 inches) above the
ground.
2. Mark and drill two 8 mm (0.315 inch) diameter holes into the wall with an electric drill.
Insert the wall plugs into the holes.
3. Align the position holes on the mount with the holes on the wall. Fasten it to the wall
with the included screws.
Installation
102 cm
(40.2 inches)
EN

8
Charging
Note:
• The vacuum cannot be used while charging.
• Fully charge the vacuum before using it for the 󽗉rst time. This will take about 2.5 hours.
• Vacuuming at Turbo mode for a prolonged period will cause the battery to heat up,
which increases charging time. Allow the vacuum to cool down for 30 minutes before
charging it.
Charging Methods
Battery Indicator
The battery indicators 󽗊ash and then turn bright constantly in sequence depending on the
battery condition.
Note: The screen will turn o󽗈 if there is no operation for more than 30 seconds.
Display Screen
Battery Status Indicator
• Red: Battery Level ＜ 20%
• White: Battery Level ≥ 20%
EN

9
How to Use
Working Methods
Select from two working methods for the vacuum, based on your needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the on/o󽗈 switch to power it on, and release it to stop immediately.
Method 2: Continuous Cleaning Mode (Electronic Lock)
Click the button to switch to Continuous Cleaning Mode and the button is on. Then
release the on/o󽗈 switch to make the vacuum in Continuous Cleaning Mode.
Use the electronic lock to free your 󽗉ngers and avoid 󽗉nger fatigue caused by holding the
switch.
Notes:
• In this mode, brie󽗊y press the switch to suspend the operation or start again，and the
working mode of the vacuum will not change.
• Click the electronic lock again to quit the Continuous Cleaning Mode.
EN

10
EN How to Use
Using Di󽗈erent Accessories
Multi-Brush Bar: Suitable for vacuuming on the med/low pile carpets, tiles and 󽗊oors.
2-in-1 Crevice Nozzle: Suitable for vacuuming cracks, corners of doors and windows,
stairs, and other hard-to-reach places.
Note:
• If any rotating part becomes stuck, the vacuum may shut o󽗈 automatically. Remove any
trapped foreign objects, then resume use.
• When the battery becomes overheated, the vacuum will automatically shut o󽗈. Wait until the
battery temperature returns to normal, then resume use.
Attachment Clip: The 2-in-1 crevice nozzle can be stored in the attachment clip as shown
when not in use.

11
Care & Maintenance
Tips:
1. Always use genuine parts to keep your warranty from being void.
2. If the vacuum is not used for an extended period, fully charge it, unplug its charger, and
store it in a cool, low-humidity environment away from direct sunlight. To avoid over-
discharging the battery, recharge the vacuum at least once every three months.
Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
Cleaning the Dust Bin & Pre-Filter
Before cleaning the dust bin, disconnect
the adapter and keep the vacuum's power
switch in the o󽗈 position.
1. Press the dust bin release button and
hold the dust bin to remove form the
vacuum in the direction of the arrow .
2. Hold the upper cover of dust bin, then
remove the cyclone assembly.
EN

12
Care & Maintenance
3. Remove the pre-󽗉lter. Rotate the cyclone assembly slightly to remove from the dust
bin.
4. Rinse the cyclone assembly, pre-󽗉lter, and dust bin until they are clean. After washing,
air dry for at least 24 hours .
Note:
• It is recommended to clean the dust bin once every month.
• It is recommended to clean the cyclone system and pre-󽗉lter at least once every 3 to 4
months.
Pre-Filter
Cyclone Assembly
Dust Bin
1
2
12
6
111
57
210
48
39 24 hrs
EN

13
1
2
Care & Maintenance
Installing Dust Bin Assembly
1. Install the cyclone assembly and pre-󽗉lter into the dust bin.
Note: Make sure all 󽗉lters are completely dry before re-installing.
2. Align the slots on the dust bin with the notches on the vacuum. Pull down the dust bin
until you hear a click.
Click
Pre-Filter
Cyclone Assembly
Dust Bin
2
1
EN

14
Care & Maintenance
Cleaning the Filter
It is recommended to clean the 󽗉lter once every 4 to 6 months.
1. Remove the dust bin as shown in the
󽗉gure.
3. Clean the 󽗉lter with clean water. Make
sure you rotate the 󽗉lter 360° to thoroughly
and remove all dust caught in the 󽗉lter.
Lightly tap the 󽗉lter several times to remove
any excess dirt.
2. Remove the 󽗉lter from the vacuum by
pulling it down in the direction shown in the
󽗉gure.
4. Allow the 󽗉lter to air dry for 24 hours.
12
6
111
57
210
48
9 3
24 hrs
Note:
• Only use clean water to wash the 󽗉lter. Do not use detergent.
• Do not attempt to clean the 󽗉lter with a brush or 󽗉nger.
EN

15
2
1
The vacuum contains a removable rechargeable lithium-ion battery pack which has a
limited number of recharge cycles. After extended use, the battery pack may no longer
hold a charge. If this happens, it means the battery pack has reached the end of its life
cycle and needs to be replaced.
1. Press down the battery pack release button and slide the battery pack to the right, as
illustrated, to remove it.
2. Install the new battery pack.
Care & Maintenance
Battery Pack
Installing the Filter
1. Insert the 󽗉lter into the vacuum and
gently press down, as illustrated.
2. Reinstall the dust bin.
Click
EN