Dreamiracle HIM-35B User manual

USER’S MANUAL
ICE MAKER
HIM-35B
THIS INSTRUCTION CONTAINS IMPORTANT SAFETY INFORMATION.PLEASE READ
AND KEEP FOR FUTURE REFERENCE.
Please give us a chance to make it right and do better!
Contact our friendly customer service department for help first.
Replacements for missing or damaged parts will be shipped.
Follow Dreamiracle
Visit us:www.dreamiracle.com

IMPORTANT NOTICES
When using an electrical appliance, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and/or injury, including
the following:
1. Read all instructions before using.
2. Remove all packing material and carefully check your ice maker to
ensure it is in good condition and that there is no damage to the ice
maker or power cord and plug.
3. Before using the ice maker for the first time, please wait 2 hours after
positioning it, and keep the transparent lid open for at least 2 hours.
4. Pure water is not allowed to be used on this unit, spring water is
recommended.
5. Ensure the voltage is compliant with the voltage range stated on the
rating label, and ensure the earthing of the socket is in good condition.
6. If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a
hazard.
7. Do not turn this product upside down or incline it over a 45°C(113°F) angle.
8. To protect against risk of electric shock, do not pour water on cord, plug
and ventilation, immerse the appliance in water or any other liquid.
9. Unplug the appliance after using or before cleaning.
10. Keep the appliance 8cm from other objects to ensure the good heat
releasing.
11. Do not use accessories which are not recommended by Manufacturer.
12. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
13. Do not use the appliance close by flames, hot plates or stoves.
14. Do not switch on the power button frequently (ensure 5min. interval at
least) to avoid the damage of the compressor.
15. Metal sheets or other electric objects are not allowed to be inserted into
the appliance to avoid fire and short circuit.
16. Do not use outdoors.
17. Never clean with scouring powders or hard implements.
01
English

18. Please keep the instruction manual.
19. Warning: Do not store explosive substances such as aerosol cans with
a flammable propellant in this appliance.
20. This appliance is intended to be used in household and similar
applications such as: staff kitchen areas in shops, offices and other
working environments; farm houses and by clients in hotels, motels
and other residential type environments; bed and breakfast type
environments; catering and similar non-retail applications.
21. When positioning the appliance, ensure the supply cord is not
trapped or damaged.
22. Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.
23. The refrigerant and insulation blowing gas is flammable, when
disposing of the appliance, do so only at an authorized waste disposal
centre. Do not expose yourself to flame.
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable
power supplies at the rear of the appliance.
Children aged from 3 to 8 years are allowed to load and unload refrigerat-
ing appliances. To avoid contamination of food, please respect the follow-
ing instructions:
– Opening the door for long periods can cause a significant increase of the
temperature in the compartments of the appliance.
– Clean regular surfaces that can come in contact with food and accessible
drainage systems.
– Clean water tanks if they have not been used for 48 h; flush the water
system connected to a water supply if water has not been drawn for 5 days.
– If the refrigerating appliance is left empty for long periods, switch off,
defrost, clean, dry, and leave the door open to prevent mould developing
within the appliance.)
Regarding the information pertaining to the use of the appliance, thanks
to refer to the below paragraph of the manual.
This symbol indicates the refrigerant R600a and the non-metal-
lic materials of the appliance are flammable. It’s a warning
symbol. Warning: Risk of fire / flammable materials.
02

03
SPECIFICATIONS
FEATURES
Quick ice making
Prompt when the ice is full and water is insufficient
Bullet ice
9 pcs ice can be made in eight minutes
Large and small ice can be made
Cleaning function
1. During transportation, do not tilt the machine more than 45 degrees, do
not reverse the machine. This may damage the compressor and the
sealing system.
2. Remove all packing materials, check the machine carefully and make
sure that the machine, power cord and plug are normal.
3. The machine should be on a level surface. To ensure sufficient
ventilation, the distance of the back of ice maker to the wall should be at
least 150 mm, it should be away from the oven, radiator or other heat
source.
4. Before using the machine for the first time, place the machine and leave
the transparent cover open for at least two hours.
5. Make sure that the home voltage is consistent with the voltage indicated
by the machine.
WARNING:
HIM-35B
15kg (33lb) / 24 hours
700g / 1.54lb (Max)
R600a
2.2L / 2.32qt
120 V
60 Hz
2.2 A
14.1" X 9.65" X 11.54"
15.67" X 11.3" X 13.52"
8.7Kg (19.2 lb)
9.7Kg (21.6 lb)
Model number:
Daily ice output:
Ice storage capacity:
Refrigerant:
Water tank capacity:
Voltage:
Frequency:
Current:
Max overall dimensions
(W×D×H):
Packing dimensions
(L×W×H):
N.W. :
G.W. :

DESCRIPTION
04
6. Distilled water is not allowed. Mineral water is recommended.
7. When the indoor temperature is lower than 15°C(59°F), small ice is
recommended. When the indoor temperature is higher than 30°C(86°F),
large ice is recommended.
Upper cover Buttons
Control panel
Water tray
Bullet evaporator
Motor support
Rear housing
Transparent lid
Micro switch support
Ice shovel board
Ice basket
Liner
Front housing
Ice shovel

05
CONTROL PANEL OPERATION
ON/OFF/CLEAN: Power switch button/Cleaning function button
SELECT: Mode selection button
ICE FULL: Ice full alarm indicator
ADD WATER: Water shortage alarm indicator
CLEAN: Automatic Cleaning mode indicator
LARGE: Large ice indicator
SMALL: Small ice indicator
1) Press the “ON/OFF” button on the LED Control Panel to begin the
ice-making cycle. Note: Once started, you cannot press the “ON/OFF”
button again to stop it. You must wait 30 seconds to allow the unit to melt
the unfinished ice cube. Also, while unit is running, you can press the
“ON/OFF” button to turn it off, but you cannot press the “ON/OFF” button
immediately to restart unit - you must wait 1 minute to allow unit to get
back into position while protecting compressor.
2) Press the “SELECT” button to select large ice and small ice modes. When
the indoor temperature is lower than 15°C(59°F), small ice is recommended.
When the indoor temperature is higher than 30°C(86°F), large ice is
recommended.
3) CLEANING FUNCTION
Plug in the power, hold the “CLEAN” button for 3 seconds to start up the
cleaning function. The "CLEAN" indicator will light up, and the pump will
start to pump water and keep running for 6 minutes, and it will automati-
cally enter into the ice-making mode after running for 6 minutes, finally,
open the drain plug and empty the water.
4) ADD WATER: water shortage alarm
When the “ADD WATER” light turns red, it means that there is water
shortage in the water tank. You need to add water and press the “ON/OFF”
button to restart the machine.
5) ICE FULL: Ice full alarm
When the ice reaches the maximum capacity of the ice storage container,
the "ICE FULL" light flashes, and the machine stops. At this time, the ice
needs to be poured out. When the ice position is lower than the full sensor
position, the machine will restart automatically.

06
OPERATING INSTRUCTIONS
Step 1
Open the lid and take out the basket and add water to the reservoir.
Note: There is a maximum scale MAX in the reservoir. The water should not
exceed the MAX position. If the water exceeds the maximum scale MAX,
you need to open the bottom drain plug, release the excess water, and
cover with a transparent cover.
Step 2
Plug in the power and press the ON/OFF button to start the machine.
In the first three cycles, the ice is small and irregular.
When the ice basket is full, please take out the ice immediately, do not let
the ice overflow the ice basket.
CLEANING & USE GUIDANCE
1. Clean the inner liner, ice collecting tray, water box, ice shovel and
evaporator frequently. When cleaning, unplug the unit and remove the
ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil. Rinse
thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in
structure, clear of obstruction. Do not use mechanical devices or other
means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have
enough water to pump for air retard, in this case, the water shortage
indicator “ADD WATER” will light up, repress ON/OFF button to restart
the ice maker is okay.
4. To ensure the cleanliness of ice, please change water from water
reservoir at least once one day. If you do not use if for a long time, please
drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or
interruption of power supply, it will delay for 3 minutes to start up after
restarted.
6. Always use fresh water before starting ice production either at initial
installation or after a long shut-off period.

07
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power
cord, or the power button has been pushed off during an ice making
cycle, small ice chips may form and lodge in the automatic shovel
causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear
of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not
remove the ice to the ice basket. If not, please push the ice shovel gently
by finger, then press ON/OFF button to restart.
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor works
abnormally with a
buzzing noise
The ice made is too
large and with pieces
sticking together
The ice making
process was correct,
but no ice came out?
All indicators twinkle
simultaneously
The machine has
been working, but the
water has been
warming
When the ice is full,
the machine does not
display the ICE FULL
Icon.
The voltage is lower than
recommended.
Ice of previous cycles left
in the water tray.
1.The compressor has no
refrigerant.
1.Water tray is blocked by
ice cube.
2.The motor is stuck, or
the motor falls off, or the
motor is damaged.
3.The micro switch was
destroyed.
Ice full sensor damaged
Sunlight interference.
2.Compressor damaged.
3.Fan motor damaged.
Solenoid broke down.
Stop the Ice maker and do
not restart until the voltage is
normal.
1.Unplug the power to take
out the ice which blocking
the tray, then plug the power
and press the POWER
button, the machine will
restart 3minutes later.
Water shortage
indicator light is on
Indicator lights on
display are not on
1.There is no water.
2.The pump is full of air.
Blown fuse/ No power.
1.Add to some water until it
reaches MAX position.
Take out the ice under the
standby state.
2.Press POWER button to
restart.
Replace fuse / Turn power on.
Call the service hotline.
Replace the solenoid valve.
1.Replace the ice full sensor.
2.Making ice indoor.
3.Call the service hotline.
2.Call the service hotline.

08
1. If the power cord is damaged; it must be replaced by the manufacturer, its
service agent or a similarly qualified person in order to avoid a hazard.
2. Fill with potable water or beverage only.
3. It is normal for the compressor and condenser surface to reach
temperatures between 70°C(158°F) and 90°C(194°F) during operation and
surrounding areas may be very hot.
4. Due to fast freezing, ice cubes may appear “cloudy”. This is air trapped in
the water and will not affect the quality or taste of ice.
5. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
6. Children should be supervised to ensure that they do not play with the
appliance.
7. Do not immerse in water.
1. Installation and operating instructions shall be provided with cautionary
statements concerning the handling, moving, and use of the ice maker to
avoid either damaging the refrigerant tubing, or increasing the risk of a
leak.
2. The installation and operating instructions shall indicate that component
parts shall be replaced with like components and that servicing shall be
done by factory authorized service personnel, so as to minimize the risk of
possible ignition due to incorrect parts or improper service.
3. The installation instructions shall indicate the ice maker is to be installed
in accordance with the Safety Standard for Refrigeration Systems,
ASHRAE 15. In addition, the instructions shall indicate the ice maker shall
not be installed in corridors or hallways of public buildings.
WARNING
WARNING
This marking indicates that this product should not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please
use the return and collection systems or contact the
retailer where the product was purchased. They can
take this product for environmental safe recycling.
CORRECT DISPOSAL OF THIS PRODUCT

Twitter: @dreamiracleclub
Facebook: @dreamiracle2020
YouTube: Dreamiracle Official
Instagram: dreamiracle_official
E-Mail: [email protected]
Made in China
Technical Support
www.dreamiracle.com
Manufacturer: Comfort Electrical Industrial Limited
NO FIRE NO WATER NO MOIST HANDS


www.dreamiracle.com
Table of contents
Popular Ice Maker manuals by other brands

GE
GE WR30X10093 installation instructions

Hamilton Beach
Hamilton Beach 840154600 Use & care guide

Lacor
Lacor PRO 69320 Instructions for use and maintenance

Follett
Follett 230V 50Hz Installation & service manual

KitchenAid
KitchenAid KUIO18NNVS1 Use & care guide

Haier
Haier HI50IB Installation and user manual