DripWorks Greenhouse Kit User manual
Greenhouse Kit Misting Assembly Instructions
Congratulations on purchasing one of DripWorks’ all-inclusive kits, the easiest way to get a
complete irrigation system setup to fit your needs. The kit has two parts; the faucet assembly
or system start portion that brings the water to your garden and the emitters that distribute
that water to your plantings.
This kit will spray 2 areas 4’ X 10’. The misters have a 2’ radius and should be placed 2’ apart. The kit
includes trellis hangers so the tubing can be suspended on trellis wire above the propagation tables.
System Start
1. At the faucet, timer, or hose end, attach the Tee Filter (FT200) then the pressure
regulator (PRSG40)
2. The Easy Loc Female Hose Start (ELFH) connects to the 1/2” mainline (see Easy Loc
instructions)
3. Connect the Easy Loc Female Hose Start (ELFH) to the pressure regulator (PRSG40)
Misters
1. Set up trellis wire over the center of the misting area at the desired height and tension
2. Unroll the mainline and allow it to relax before attaching to the trellis 6. Use the Easy
Loc tee (ELT) to split the mainline over the tables
3. Make a hole in the mainline with the punch (PUKEY) and insert the misting assembly so
it is oriented to spray on the bed or table (the distance should be 2’-3’)
4. Turn the water and flush the lines then close the mainlines with Figure 8 Ends (CF8)
If you have any further questions about our products, or installing your drip system, please
contact us at 800-522-3747 or via email at support@dripworks.com or visit our store at
DripWorks, 190 Sanhedrin Circle, Willits, CA 95490
Table of contents
Other DripWorks Lawn And Garden Equipment manuals
