DRONEDEFENCE AEROPING User manual
AEROPING
SETUP GUIDE
AeroPing Drone Remote-ID Module
AEROPING
SETUP GUIDE
DRONEDEFENCE.CO.UK
TOP VIEW
SIDE VIEW
‘FLY’ mode
‘SET’ mode
Status LED
Charge LED
DEVICE OFF
AEROPING
DRONEDEFENCE.CO.UK
SETUP GUIDE
Slide the side switch to ‘Set’.
2.
CONTINUED OVERLEAF
LED will pulse red.
3.
Open your mobile device’s ‘Wi-Fi’ settings.
4.
From the list, select ‘AeroPing-Config’.
5.
Enter your ‘Operator ID’ and ‘Operator Description’.
6.
Click ‘Submit’.
7.
TO GET STARTED...
1. Ensure your AeroPing is fully charged. This is crucial to establish the
initial GPS connection.
Operator ID - Enter your pilot ID, drone operator ID or Part 107 license number.
(Please note Field is 21 character alphanumeric. Do not enter any special characters.)
Operator Description - Enter the reason for your drone flight
(E.g. Drone aerial survey, photography, filming event etc.)
AEROPING
DRONEDEFENCE.CO.UK
SETUP GUIDE
CONTINUED OVERLEAF
Attach AeroPing to drone with velcro squares (included) or velcro strap.
9.
Slide AeroPing side switch to ‘Fly’.
10.
Begin your flight.12.
Secure the enclosed velcro stickers to the AeroPing and your drone.
8.
UPDATING YOUR FLIGHT DETAILS
1. Access the ‘AeroPing-Config’ once page again.
2. Delete the current saved information and re-type the updated info.
3. Click ‘Submit’ once again. This will save over the old data.
LEDs will flash red and green whilst a GPS connection is established.
Once connected, the LED will turn solid green.
(Please note - the module must be outside to obtain a GPS signal)
11.
CONTINUED OVERLEAF
DRONEDEFENCE.CO.UK
Table of contents
