DSPPA MAG6310 User manual

Public Address System
Network Display System
MAG6310
User’s Manual
Thank you for using our DSPPA public address system. Please read this User Manual carefully to
make better use of this equipment.
G u a n g z h o u D S P P A A u d i o C o . , L t d .
HTTP：//www.dsppatech.com

1. Product description
1.1 About MAG6310
MAG6310 network display terminal is a networked all-digital analog-digital conversion signal
processor based on TCP/IP transmission protocol, which adopts the dual network design, and can
be coupled at any place with access to network. The remote audio data stream can output the audio
signal through the machine with intelligent control of the host; built-in MP3 player, and is provided
with USB and SD. MP3 program can be played when the network audio stream signal is not played;
it can be separated from the host machine to implement the timing point independently; 1-channel
AUX audio input interface is used to connect other audio source device (such as DVD), and
1-channel AUX audio output interface is used to connect other power amplifiers, so as to expand
the power; there is a way microphone interface, so as to realize local paging and so on.
1.2 Performance features
Dual network interfaces and support to work across the network segment;
Can be mounted anywhere with network;
Built in with an MP3 decoding player
Support maximum sampling rate of 16bit 48kHz digital audio stream decoding;
Built-in 2 × 15W high-fidelity digital amplifier, low-power settings;
Can play background music, emergency paging and alarm signals from system host;
With 1 AUX input & output, 1 mic inputs and 1 EMC output, 1 short circuit output;
Local output volume and local play status can be controlled;
Operating status and information changing digital display;
Can be remote controlled by infrared remote;
1

2. Appearance Description
2.1 The introduction of side panel
LAN2LAN1 Micro SDUSB Disk
Data
(注意:此端口不允许连接网
络交换机,否则会烧毁设备!)
MIC2
DC +15V
AUX IN
COM
+15V
SC
COM
SP+
SP- SP-
SP+
1367
8 9 10
24 5
1. Power supply interface
2. Output for Speaker
Built-in 2×15W digital power amplifier, the output power is 15W. They are connected with two
constant resistance (4Ω) sound box respectively. The size of speaker line （20AWG-22AWG）
3. EMC override play output
The signal output from the interface is controlled by the host machine
4.Auxiliary output interface (AUX OUT）
It is connected with other power amplifiers, so as to expand the terminal power.
5. Auxiliary input interface (AUX IN)
Connect the audio source device (such as DVD) to expand the program source for the machine.
6. MIC2 interface
Connect the microphone to realize local paging, site talking and other functions.
7. DATA
Extension device interface. The connection method is as follow: connection graph 3.3 (Notes:
This port is not allowed to connect to the network switch, otherwise it will burn the device)
8. Network interface（LAN1/LAN2）
9. USB (USB Disk)
Insert U disk at the interface or connect the portable hard disk and other memory device, and
provide the program source for the built-in MP3 player
10. SD interface (Micro SD)
2

Insert the SD card saved with host timing point at the socket. When the terminal is disconnected,
the host machine plays the audio source at the definite time.
3. Diagram example
3.1 MAG6310 terminal application schematic diagram
1. Only the schematic description for connection of rough application of MAG6310
terminal is made in the above figure. For connection of the whole system, please refer to operation
instructions for the networked control host.
2. It is illustrated by examples in the above figure. For specific connections, please refer to
the schematic diagram of system connection.
3. MAG6310 terminal must be connected in the system through the network switch, and the
corresponding address shall be arranged for connection with the host machine
Packing List
S/N
List
Quantity
1
Network display terminal
1
2
Adapter 14V/3A
1
3
3000MM/8 mm cable
1
4
Crystal head
2
5
10P Green plug 2.5MM
1
6
Manual
1
7
Guarantee card/Conformity certificate
1/1
8
SY542（Audio line）
1
9
3.5mm Audio plug
1
Guangzhou DSPPA Audio Co., Ltd.
Other equipment of the network
Network broadcasting system
Other networks or equipment
Control host of the network broadcasting system
以 太 网
Terminal
Terminal
Terminal
Terminal
Caution
●The device is not completely disconnected from power source when it is
switched "OFF". For sake of safety, please disconnect the device from the
socket if it is not in use.
●Please keep this device off water drops or splash or vase filled with water or
any other articles of similar nature.
●Please do NOT remove the cover of the equipment, otherwise you may get an
electric shock. Where necessary, repair to the equipment should be conducted
by qualified professionals.
●All terminals on the device marked with are live and dangerous, and
should be connected by trained personnel.
●This is connected to power source via the plug and any failure or danger
occurs, the user can disconnect the device from power source by pulling out
the plug out from the socket, therefore, it is required that the power socket
should be located somewhere with easy access.
3

4. Set operation instructions on the host
To extend the player terminal MAG6310 in the network PA system, set the following configuration parameters to
connect the terminal and the host.
（1）Offline timing point function：Two modes can choose: Start/Disability. You can decide to start the offline timing
point function or not based on your own need. When you need, select the “Start” and press the “submit” button.
On the contrary, choose the “disability”.
（2）On demand panel terminal function ：Click “fixed” option, the terminal is fixed to on demand panel terminal;
Select “dynamic” option, it will be the on demand panel terminal when plug in n demand panel. Otherwise it is a
common play terminal.
（3）Local network priority ：Three priority modes. Choose the “local” option, local source output priority. The
"network" option is the same. Choose the “mixed”, the local and network output at the same time.
（4）Microphone selection:：The type of capacitor or coil can be choose base on your own need.
3.2 MAG6310 diagram
Except for MP3 player and the network audio source carried in the machine, a way auxiliary input and a way
auxiliary output are also arranged to connect other audio sources and power amplifiers. The customized design can
satisfy demands for high power and multiple audio sources on terminal site. The peripheral audio source and other
power amplifiers may not be connected in the application without such individual demands. The MP3 player and
network audio stream carried in the machine can realize sound amplification at most public places.
The schematic diagram of interface connection of the machine is shown in the following figure
Two 4Ω,15W fixed resistance speaker
Note：
The diameter size of speaker line（20AWG-22AWG）
LAN2LAN1 Micro SDUSB Disk
Data
(注意:此端口不允许连接网
络交换机,否则会烧毁设备!)
MIC2
DC +15V
AUX IN
COM
+15V
SC
COM
SP+
SP- SP-
SP+
CD Player
AUX IN
COM
+15V
SC
COM
SP+
SP- SP-
SP+
Power Amplifier
Ethernet switcher
4

3.3 Data interface description
Note:
（1）Adopt 8 dedicated data plugs, from the top to bottom respectively: ①OUT+ 、
②OUT-、③ IN+、 ④B、⑤ A、⑥ IN-、⑦ +14V、⑧ COM。
（2） ①and ②:Analog audio differential output；
③and ⑥Analog audio differential output；
④and ⑤485 communication interface output；
⑦:14V output；
⑧: Ground lead.
Specification:
Indicator item
Indicator
Model
MAG6310
AUX IN
Input sensitivity
350 mV
Frequency response
26Hz-18kHz
Distortion
≤0.5%
SNL
≥75 dB
AUX OUT
Rated output
1000mV
Frequency response
25Hz-20kHz
Distortion
≤0.3%
SNL
≥75 dB
Distortion
Distortion
3.5mV
Distortion
30Hz-18kHz
Distortion
≤0.5%
SNL
≥65 dB
USB/SD
/NET/MP3 Display
Frequency response
25Hz-20kHz
Distortion
≤0.5%
SNL
≥70dB
Capacity of SD card supported
32GB
Capacity of U disk supported
32GB
Power supply
AC220V/50Hz-60Hz
Display screen
Digital Screen
Weight
1.20kg
Dimension（L×W×H mm）
132×140×50mm
LAN2LAN1 Micro SDUSB Disk
Data
(注意:此端口不允许连接网
络交换机,否则会烧毁设备!)
MIC2
DC +15V
AUX IN
COM
+15V
SC
COM
SP+
SP- SP-
SP+
8位数据插头
8 data plug
5