DualLite OCR-03L Manual

WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
OCR-03L
LED Outdoor Emergency Remote Light Fixture
Installation, Operation and Service Instructions
Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright © Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A.
93158905_A 11/5/21
All steel, aluminum and thermoplastic parts are recyclable.
NOTICE: Emergency units contain rechargeable batteries which
must be recycled or disposed of properly.
RECYCLING INFORMATION
Replacing LED Lamps
The LED lamps inside the unit are not replaceable or field serviceable. Please see dual-lite.com for further assistance.
Troubleshooting
Emergency circuit does not work
• Check wiring connections
SERVICE/MAINTENANCE
93158309, 93158310
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
Do not let power supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at heights where it will not readily be
subject to tampering by unauthorized personnel.
The use of accessory equipment not authorized by the manufacturer may cause an
unsafe condition.
Do not use this equipment for other than its intended purpose.
Servicing of this equipment should be performed by qualified service personnel.
Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency lighting
units once a month for a minimum of 30 seconds, and once a year for a minimum of
90 minutes.
INSTALLER:
• SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
1.
2.
3.
4.
5.
6.
7.

REPLACEMENT HEAD INSTALLATION
Step 1
FIXTURE INSTALLATION
The OCR-03L fixture can be wall mounted or ceiling mounted at a height of 7ft to 10ft. The
LED lamps can be adjusted to desired position. The lamp heads can be locked in desired
posisiton using the lock nut and screw.
Step 3
Step 2
NOTE:
Configuring the number of OCR remotes requires calculation of total wattage capacity
based on the capacity of the fixture powering the remotes.
Install DC wiring (12-18AWG depending
on wire length) from J-box for wall or
ceiling mount.
Install the mounting plate to the
J-box using the provided gasket
and appropriate J-box screws
(J-box screws not provided). NOTES
12-18AWG
DC wiring (+)
12-18AWG
DC wiring (-)
Connect ground
(copper) conductor
OCR-03L wattage for calculation:
OCRSB-03L = 3W
OCRSW-03L = 3W
OCRSZ-03L = 3W
OCRDB-03L = 6W
OCRDW-03L = 6W
OCRDZ-03L = 6W
•
•
•
•
•
•
Connect the ground wire
from the building to the
back plate with the screw
provided.
Step 1
Remove the cotter pin
from the old lamp head.
Step 2
Cut the wires of the old
lapm head.
Unscrew the old lamp head
from the base plate.
Step 3
Remove the cotter pin from the new lamp head.
Screw in the new lamp head.
Step 4
Connect the red and black wires.
Insert the cotter pin back in the screw head.