Dunlop EP101 User manual

92503016712revA
EP101 ECHOPLEX PREAMP

EP101 ECHOPLEX®PREAMP
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: [phone] FAX: [phone]
CONTROLS
GAIN knob controls amount of
gain added to signal
FOOTSWITCH toggles eect on/
bypass (blue LED indicates on)
POWER
The Echoplex®Preamp is powered
by one 9-volt battery (remove
bottom plate to install), a 9-volt
AC adapter such as the Dunlop
ECB003/ECB003E, or a DC Brick™
power supply.
DESCRIPTION
• The EP-3’s legendary tone
conditioning mojo in a Phase
90-sized box
• Adds up to +11dB of gain
• Warm, light overdrive at
higher levels
• True Bypass
DIRECTIONS
• Run a cable from your guitar to
the Echoplex Preamp’s INPUT
jack and run another cable from
the Echoplex Preamp’s OUTPUT
jack to your amplier.
• Start with the GAIN control at
Position 5 (+0dB).
• Turn the eect on by depressing
the footswitch.
• Rotate the GAIN knob clockwise
to increase gain (up to +11dB) or
counterclockwise to decrease it.
• Starting at position 7, the
Echoplex Preamp will produce
light overdrive clipping.
TONE CONDITIONING TIPS
• Start with the Echoplex Preamp
at the end of your eects chain.
In this position, the EP101 will
sweeten up the sound of the
entire chain and also act as a
buer.
• For a dierent sound, try placing
the EP101 after your gain pedals
(boost, overdrive, distortion,
fuzz) but before your modulation
pedals (phaser, anger, chorus,
delay, etc.).
• To use the EP101 as a true
preamp, or as a lead boost,
put it at the beginning of your
eects chain.
SPECIFICATIONS
Input Impedance 730 kΩ
Output Impedance* 55 kΩ
Max Input Level -5 dBV
Max Output Level +5.5 dBV
Noise Floor** -95 dBV
Max Gain +11 dBV
Bypass True Hardwire
Current Draw 12 mA
Power Supply 9 volts DC
*Gain at middle position
**A-weighted, Gain at maximum
clockwise position