
76
Installing the product
Place the mount on the base of the product,
slightly turn counterclockwise to lock into the
base and tighten with the locking ring on the
bottom side.
Attach the fan blades to the motor.
Use the plastic screw to secure the fan blades.
Note: turn the screw anticlockwise rmly to
secure it.
Place the rear grill over the motor and tighten
with the locking ring.
mount
base
locking ring
2
Fit the front grill and rotate it a little, clockwise,
until the arrow on the grill lines up with the
left-side marker.
Fit the supplied screw to the underside of the
grill and connect the two halves rmly together.
OPENCLOSE
Installing the remote control
Remove the lid
Place the battery according to the instructions
on the lid with the correct polarity
Close the lid
Note:
• Only use 1x CR2025 3V batteries
• Non-rechargeable batteries are not to be
recharged
• Exhausted batteries are to be removed from the
remote control and safely disposed of
• If the remote control is to be stored unused for a
long period, the battery should be removed
• The supply terminals are not to be short-circuited.
1
2
3
• Keep children away from playing with the device.
• Do not pull the unit along by the cord.
• If the supplied power cord is damaged it must be
replaced by an electrician or qualied person to
avoid any hazard.
• The mains supply must conrm to the
specication shown on the rating label on the
back of the device.
• Close doors and windows for optimal eciency.
• Keep curtains or blinds closed during the
sunniest hours of the day.
•Do not turn on the device if you have discovered
damage to the appliance, cord or plug or if the
device is malfunctioning or if there are signs of
any other defect. Return the complete product to
the point of purchase or to a certied electrician
for inspection and/or repair. Always ask for
original parts. The device (incl. cord and plug)
may only be opened and/or repaired by properly
authorized and qualied persons.
• Only a licensed professional is allowed to
dismantle or modify the device.
• This device is to be used only for its prescribed
purpose. Any other use is deemed to be a
cause of misuse. The user/operator, not the
manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
1
3
4
5
6
EN
Note: make sure that the grooves in the fan
blades are slid over the pins