Dveo OnRamp/IP User manual

OnRamp/IP™ Quick Start Guide
November13,2012
For sales information and technical support contact:
11409 West Bernardo Court
San Diego, CA, USA 92127
Phone: [phone]
Fax: [phone]
[email protected]
http://www.dveo.com
© 2012 Computer Modules, Inc. DVEO and OnRamp IP are trademarks of Computer Modules, Inc. All other trademarks
and registered trademarks are the properties of their respective owners. All rights reserved. Specifications are subject to
change without notice.

Network Setup:
1) Unpack your OnRamp/IP, power it up and connect two network cables from the
OnRamp/IP to a switch.
2) Connect your PC to the same switch (alternatively, you could use a crossover
cable between your computer and the OnRamp/IP).
3) The IP address for the OnRamp is on a label on the back of your system, just
above the WAN port. Use this IP address to enter the web interface.
4) At the password prompt, enter admin for username and admin for password.
These are the default security credentials.
5) Go to the “Network Setup” tab (the second from right tab) and configure all the
network adapters on the OnRamp/IP.
NOTE: Some of the web interface sections will only show up if you have purchased
that option.

6) Once you have changed all the settings, go to Toolbox ->Reset Unit and click on
Reboot Now.
7) Re-IP the network adaptor on your PC to match what you configured on the
OnRamp/IP and connect to the web menus again.
8) If you ever lose connectivity with the unit and cannot get back in, you can use a
keyboard and monitor to get access to the emergency recovery menu to lookup
the current IP address and/or reset the machine to factory defaults.

Programming the Streams:
This example shows ASI to IP. The setup screens are similar for all video formats.
9) Go to the Stream Setup tab, ASI #1 Setup, and define an input. Make sure to
specify a name, enable the input and click on Update.
NOTE: To save your changes, always select Update.

10) Go to the New Output tab to the right of Input Setup. Select Enabled. Enter
the Stream Name of the input you just defined.
11) At Input Program(s), input the program number for the program desired. (For
single program transport streams, enter the program number.)
12) Video Transcoding Format and Audio Transcoding Format: Transcoding is
not enabled on the OnRamp.
13) Edit all the remaining parameters of your output stream and select Update.
14) You can repeat steps 9 and 10 for all the output streams associated to a particular
input.

Start Streaming
15) When all the output streams have been defined, go back to Toolbox and click on
the Service Control icon. Select one or more streams and click Start.
16) You should be able to see all the output streams on the network now.

17) To check the status of the streams, go to System Status ->Tuner Status. You
should be able to see the throughput in the appropriate network adaptors.