Dynojet Power Commander III User manual

Accelerator Pump For All PCIII USB Units - 1
New Accelerator Pump feature for all
Power Commander III USB units
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Dynojet is pleased to announce a new
“Accelerator Pump” feature for all USB
Power Commanders. This is a FREE
upgrade that can be installed into any
USB Power Commander.
Step 1 - Download the Accelerator
Pump utility file from
www.powercommander.com.
Step 2 - Connect to the Power
Commander and run the utility
Step 3 - Experiment with the settings to
match your riding style.
You can adjust:
A) The amount of fuel to add
B) The number of engine revolutions
during which fuel is added
C) The sensitivity of throttle move-
ment under which the accelera-
tor pump is activated

Fig. EFig. F
Q. I have a Power Commander III. Can I use this
utility?
A. No, the Power Commander II and III hardware can-
not support this feature.
Q. What are the best settings for my bike?
A. There are no magical settings. Different riders on
the same bike would choose different settings
based on their riding style.
Some Racers have selected the following:
75% Sensitivity
20% Fuel Increase
15 Engine Revolutions
Some Street Riders have selected:
90% Sensitivity
15% Fuel Increase
20 Engine Revolutions
To use this feature, you will have to experiment with
different settings to suit your riding style.
Fig. AFig. BFig. CFig. D
Accelerator Pump For All PCIII USB Units - 2www.powercommander.com
Frequently Asked Questions