earth worth 1852 User manual

2 - Assemble top and bottom sections of the tent frame as shown below.
Layout a square with poles C and D opposite each other and insert onto connectors A as shown.
Layout a square with poles E and F opposite each other and insert onto connectors B as shown.
3 - Connect the upper and lower tent frames to each other as shown, you may require assistance or need to lay
the frame halves on oor.
Tent
Tent Bottom
Grow Tent Assembly Instructions
Parts:
1 - Lay tent canvas at on oor
and unzip all zippers as shown.
Connector A x 4
Connector B x 4
Pole C x 2
Pole D x 2
Pole E x 2
Pole F x 2
Straight Support G x 1
Support Pole H x 2
TM 1852 EW-48x48x78 Mylar Hydro Shanty
C
C
D
D
A
A
A
A
E
F
BB
BB
C
C
D
D
A
A
A
A
E
E
F
FB
B
B
B
F
E
Copyright 2011 DTX International
www.earthworth.com

4 - Place assembled frame structure into the bottom panel of the tent as shown, then drape the canvas over
the structure from the back.
5 - Close the zippers from both sides to align the canvas to the frame.
6 - Open the zippers fully to install supports into the top portion of the inside of the tent.
G Straight support is to be installed from front to back, H supports span the width of the top.
Instructions - continued
Back
Front
Front
7 - Insert liner tray into the bottom of the tent fastening the ties around the connector poles.
8 - Assembly is now complete. Close zipper, make any small adjustments needed to ensure the best t on the
frame and your grow tent is ready to use!
Copyright 2011 DTX International
www.earthworth.com
Back
G
G
H
H
H
H