Eastbrook VALIANT User manual

VALIANT AND VOLENTE WALK IN PANELS
880-900 660-680
985-100 0
1180-1200
680-700
740-760
780-800
480-500
720-740
760-780
860-880
960-980
480-500
This product should only be fitted by a fully qualified installer.
This product must be unpacked and checked for quality prior to
installation.
Any missing parts or damage must be reported to your supplier
within 10 days of purchase and before installation.
No claims can be enforced outside of these terms.

B
A
K
GI
X1
ST4*30
ST4*12
H
CD
F
(L)、(R)
E
J
X1 X1 X1 X1
X2 X1
X6
X4 X4 X6
(1)
LIST OF SPARE PARTS
TOOLS REQUIRED
Silicone gun
Spirit level
Tape measure
Rubber hammer
Electric drill
Flat an d cross
screwdriver
( 6、3. 2)
c
Pencil Dri ll bi t
L
ST4*12
X2
Please make the following checks before connecting the installation:
The product supplied is the required size and the adjustment
is compatible with the site situation.
Check all component parts are present, see packing list and
product schematic diagram for reference.
Make sure you have all the required tools.

(2)
PRODUCT SCHEMATIC DIAGRAM

(3)
12
3 4
A
J
K
6m m
Dry fit required for best position
to connect wall profile.
Drill holes and fit wall plugs if a solid
wall substitute for hollow wall fixings
if necessary (not supplied).
Fit panel into wall profile.
Screw wall profile A to wall with
ST4*30 K screws.

(4)
5
3.2mm
1
2
3
H
I
B
AB
Choose required position for wall support bar.
Drill guide holes into profile attached to glass panel with 3.2mm drill bit
through existing holes in wall profile at chosen adjustment and secure
with washer I and ST4*12 H screws provided.
Push screw cover profile B onto washers.

(5)
6mm
1 2 3 4
1234
EJ
K
5
Attach brackets D & E to bar ensuring D
is in the correct position, and fix with
screws supplied.
Fit support bar wall bracket E in position required with ST4*30 K screws provided.
Substitute wall plugs J for hollow wall fixings if necessary.
Connect bar C to wall bracket
E with screw provided.
Attached glass clamp D to
panel with screws provided.
Check all screws are secured
correctly.
Cut bar C to correct length.
Separate wall bracket D and E into
component parts and attach to bar C
with screws provided.

(6)
Silicone
gun
12
Silicone as illustrated ensuring silicone
sealant is on the outside only.
13
Silicone as illustrated ensuring silicone sealant is on the outside only.
Silicone
gun
Silicone
gun
Fit wall profile corner caps
G and F .

S-277
Cleaning & Maintenance
(7)
Don’t clean the shower enclosure with irritant detergent
such as alcohol,bleach or other chemical cleaners.
Only clean with warm soapy water .
Helpline:01452 317890