The Digital Watch (1) uses one LR41 (1.5V X 1) battery (included).
Follow the steps below to replace the battery when required.
1. Remove the two screws from the back of the spy listener
(a) with a screwdriver (not included).
2. Take out the watch module (b) from the case. Loosen the
two screws holding the metal plate of the watch module
with a small Phillips/cross head screwdriver (not included).
3. After the metal plate (c) is removed, take the old battery
out. Insert a new LR41 battery (d), with the “+”side on top.
4. Replace the metal plate, the watch module and the back
cover.
F. LED Indicator
The LED indicator will show the status of the walkie talkie
LED Indicator State
Flashing (Fast) Pairing in progress
Flashing (Slow) Idle (Waiting for transmission)
On (Constant) Transmitting/Receiving
Off Walkie Talkie is OFF or in Power-Save Mode
G. Troubleshooting Your Super Digital Walkie Talkie
Batteries required:
Walkie Talkies –6 x AG13 (LR44) (1.5V X 3) (included)
Digital Watches –2 x LR41 (1.5V X 1) (included)
IMPORTANT: Keep these instructions. DO NOT DISCARD.
1. Only adults should install and replace batteries.
2. Alkaline batteries are recommended.
3. If the toy has not been used for a long time, remove the batteries.
4. Do not mix old and new batteries.
5. Do not mix alkaline, standard (carbon zinc) or rechargeable (nickel cadmium) batteries.
6. Exhausted batteries are to be removed from the toy.
7. The supply terminals are not to be short-circuited.
8. Non-rechargeable batteries are not to be recharged.
9. Rechargeable batteries are to be removed from the toy before being charged.
10. Rechargeable batteries are only to be charged under adult supervision.
11. Only batteries of the same or equivalent type as recommended are to be used.
12. Batteries are to be inserted with the correct polarity.
13. Do not dispose of batteries in fire, batteries may explode or leak.
14. Batteries may explode or leak if misused.
Note: Under the environment with electrostatic discharge, the device may
reset and require user to switch off and switch on and set the time again.
FCC Information FCC ID: OIJSI0101
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions:
•This device may not cause harmful interference.
•This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s
instructions, may cause interference harmful to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio or TV technician for help.
