Eaton CBEU-02 Manual

1
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation
MA-CDEU_02/03.qxd / 06.2019e / IL019106ZU / 136211187
All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Binary Input
CBEU-02/03
OFF
868.3 MHz
IP20
Mode 1, 2, 3, 4
1.5 mm2
10 mm
Local input
A
B
Reset
Input
Mode
Technical Data / Technische gegevens / Tekniske data /
Technische Daten / Technická data
Power supply 230 VAC +10% -15%, 50 Hz
Power standby (Typical) 230 mW
Local Input 230 VAC (Max. 265 V)
Binary Input voltage Maximum 265 V (Same phase)
Input contact resistance < 10 kΩreliably ON,
IN to L > 50 kΩreliably OFF
Voltage difference < 1 V reliably ON
IN to L > 3 V reliably OFF
Dimensions 49.5 x 45.5 x 18 mm (H x W x D)
MRF Version 2.44
Instruction Leaflet
Montageanweisung
Notice d’installation
Instrucciones de montaje
Istruzioni per il montaggio

Инструкция по монтажу
Montagehandleiding

Montagevejledning
Οδηγίες εγκατάστασης
Instruções de montagem
Monteringsanvisning
Asennusohje
Návod k montáži
Paigaldusjuhend
Szerelési utasítás
Montāžas instrukcija
Montavimo instrukcija
Instrukcja montażu
Navodila za montažo
Návod na montáž
Монтажни инструкции
Instrucţiuni de montaj
Upute za montažu
Kullanma Talimatı
Инструкција за монтажу
Intruksjonsblad
Монтажна інструкція
ت ا ة 
136211187_136211187 24.06.2019 10:38 Seite 1

2
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation
MA-CDEU_02/03.qxd / 06.2019e / IL019106ZU / 136211187
All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Wiring diagrams / Aansluitschema's / Koblingsskjemaer /
Schaltpläne / Schéma zapojení
CBEU-02/03
12…
n
12…
n
1…
n
136211187_136211187 24.06.2019 10:38 Seite 2

3
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation
MA-CDEU_02/03.qxd / 06.2019e / IL019106ZU / 136211187
All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Back to factory default / Terug naar fabrieksinstellingen / Tilbake til fabrikkinnstillinger /
Auf Auslieferungszustand zurücksetzen / Zpět na tovární hodnoty
Set Local Input Mode / Lokale Ingang toewijzen / Tildele Lokal Inngang /
Zuweisung lokaler Eingang / Přiřazení místního vstupu
Push button / Pulsdrukker / Trykknapp /
Tastfunktion / Tlaèítko
Switch / Schakelaar / Bryter /
Schalter / Pøepína
Mixed / Gemengd / Blandet /
Mixed / Smíšená
Rocker / Tuimelschakelaar / Vippebryter /
Wippschalter / Kolébkový spínaè
136211187_136211187 24.06.2019 10:38 Seite 3

4
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation
MA-CDEU_02/03.qxd / 06.2019e / IL019106ZU / 136211187
All Rights Reserved / Printed in Austria
www.eaton.com/recycling
EU
- type examination performed by:
TÜV Austria Services GmbH, Notified Body
1230 Vienna, Deutschstrasse 10, Austria
Affixing date of CE mark:
2015
Doc.Id.:
CBEU-0203_171117
Senior Vice President Director Quality
General Manager & Systems
Friedrich Schröder
Fernando Ceccarelli
Declaration of Conformity
We, EATON Industries (Austria) GmbH
3943 Schrems, Eugenia 1
Austria
declare under our sole responsibility that the product (family)
Eaton - Binary input with 230VAC power supply,
CBEU-02/03 (contains RF-Modul CSCZ-01/xx)
(the declaration of conformity applies to all
listed types within our actual product catalogue)
provided that it is installed, maintained and used in the
application intended for, with respect to the relevant manufacturers
instructions, installation standards and “good engineering practices”
complies with the provisions of Council directive(s):
RED Directive 2014/53/EU
RoHS Directive 2011/65/EU
based on compliance with following standard(s):
EN 301489-3 V2.1.1, EN 300220-2 V3.1.1, EN 60669-2-1:2010,
EN 50428:2005+A1:2007+A2:2009, EN 55015:2013, EN 61547:2009,
EN 50491-5-1:2010, EN 50491-5-2:2010, EN 60950-1:2006 + A11:2009
+ A1:2010 + A12:2011 + A2:2013, EN 62479:2010, EN 50581:2012
17.11.2017
136211187_136211187 24.06.2019 10:38 Seite 4