Eco Tech Time EGTB-10427-21MB User manual

Trend News Europe GmbH –Eichholzer Str. 3c –D-21436 Marschacht ENG GPS610c 09/15
1 / 3
Congratulations for purchasing a GPS wrist watch that can receive precise time signal anywhere in the world
GPS 610C –Product features:
Display:
Hours, minutes and seconds
Functions:
Date, time zone, and display of the latitude of the watch’s location
Automatic and manual GPS transmitter call (RX-Position)
Manual changeover of time zones is possible
Automatic changeover between summer and winter time depending on the time zone
Reception check: (“OK”= OK / “NG”= not good)
Flight mode
Light function
Battery life: approximately 3 to 6 years (coin cell type: CR3032)
The Global Positioning System (GPS) is a space-based navigation system that provides information about the location and time in
any weather and anywhere on or near the earth where a clear view of four or more GPS satellites is available. With a GPS receiver it is
freely accessible for everyone.
The GPS signal is transmitted over a linear distance and it can pass through across clouds, glass and plastic, barring most solid
objects like buildings and mountains.
The time data from the GPS signal travel always within a micro-second of the UTC (Coordinated Universal Time), which is regulated by
the satellites’ atomic clocks. The receiver in a GPS enabled watch synchronizes the watch with the GPS time. In other words, a GPS
enabled watch essentially runs at the precision of an atomic clock (precision +/- 1 second per 1 million years).
Considering the fact that the GPS receiver maintains connection to four or more of the GPS satellites orbiting the earth at a distance of
approximately 20,000 km, the watch can localize the earth’s position exactly. By comparing this positional data with the database
stored inside the GPS enabled watch, it computes the time in 39 time zones and indicates always the precise local time anywhere in
the world.
(Symbols on the watch’s face)
Please note that your wrist watch is capable of receiving the GPS signal only outdoors under the open sky. Buildings, vehicles or dense vegetation act
like a shield for the GPS signal and, in most cases, can hamper the signal reception in your GPS wrist watch. Under the open sky, the watch may take
nearly 10 to 120 seconds to retrieve the signal completely.
Button (B)
RX reception /
signal control and
latitude
RX Time / Date
Button (A)
Display / Zone
RX Time / Zone /
Date
Button (C)
Time zone / Light
Manual setting
time zone
Short User Guide / Basic setting for GPS 610c (Must be carried out under the open sky.
Clear sky and horizontal position of the watch, facing up are adventurous.)
Please follow the instructions in Step “B2. Manual signal reception for the time of the day
or time and time zone.”Thereafter, your GPS watch is fully functional.
ENGLISH
Legend:
RX = Reception
= 1 sec. push of button
= 5 sec. push of button

Trend News Europe GmbH –Eichholzer Str. 3c –D-21436 Marschacht ENG GPS610c 09/15
2 / 3
A) Functions of the seconds hand
Make sure that the crown of your GPS wrist watch is fully pushed into 0 position, and that the seconds hand is running at seconds pace.
A1. Reception check for the GPS signal and display of the latitude
Press just once the button (B) at the top right.
If the GPS signal reception was successful, the seconds hand jumps to “OK”. If the reception was unsuccessful, the seconds hand will point to
the position “NG”.
Thereafter, the seconds hand will display the latitude of your location. After about 5 seconds, the watch’s hands will revert to the last set time
of the day.
A2. Date display
Press once the button (A) at the bottom right to display the date (day of the month).
The seconds hand will now jump to the date. After about 5 seconds, the watch’s hands will revert to the last set time of the day.
A3. Checking the current time zone and the light function
To check the currently programmed time, press once the button (C) ZONE on the left side.
The seconds hand will now jump to the relevant time zone. At this point, the LED power light turns on. After about 5 seconds, the watch’s
hands will revert to the last set time of the day.
B) GPS signal reception
This GPS wrist watch is capable of receiving the signal automatically. This happens weekly around midday by automatically retrieving the
signal. The watch also has the option to retrieve the signal manually.
B1. Automatic signal reception / Retrieval of signal
The watch receives the signal automatically anywhere between 11:00 and 14:00 hours (i.e. 11:00 am and 2:00 pm). This means retrieving the
data for the time of the day. In this operation, the time zone set already will not be changed or adjusted –regardless of the location.
B2. Manual signal reception / Retrieval of signal (Must be carried out outdoors under the open sky. Clear sky and horizontal position of the
watch, facing up are adventurous.)
Make sure that the crown of your GPS wrist watch is fully pushed into 0 position, and that the seconds hand is running at seconds pace.
The signal can be received manually in 2 different ways.
1. Manual signal reception for the time of the day (Step B.2.1., at least reception from 1 satellite is needed.)
2. Manual signal reception for the time of the day and the time zone (Step B.2.2., at least reception from 4 satellites is needed.)
B.2.1. Manual signal reception for the time of the day (do this outdoors)
To receive the signal for the time of the day manually, press the button at the top right (B) for about 5 seconds. The seconds hand will now
rotate to the “RX”position and the watch begins to receive the signal for the time of the day and, after receiving the signal, the watch’s hands
are set to the current time. This operation may take up to 90 seconds. If not successful, please repeat.
B2.2. Manual signal reception for the time of the day and the time zone (do this outdoors)
To receive the signal for the time of the day and the time manually, press the button at the bottom right (A) for about 5 seconds. The seconds
hand will now rotate to the “RX” position.
The signal for the time and the time zone is received. This operation may take up to 90 seconds.
If the signal was received successfully, the time of the day and the time zone are set, and the summer or winter time are updated correctly. If
not successful, please repeat.
If the correct time and time zone is not displayed, please re-calibrate your watch according to point E).
C) Manual changeover of time zone
The time zone of your GPS enabled wrist watch can be manually changed, even if no GPS signal is available, for example, during a flight.
Make sure that the crown of your GPS wrist watch is fully pushed into 0 position, and that the seconds hand is running at seconds pace.
To change the time zone manually, do as follows:
Press the button at the bottom left (C) for about 5 seconds. The seconds hand will now rotate to 12:00 o‘clock.
Press the button at the bottom right (B) to select any time zone using the seconds hand. You can read the time zones marked on the
respective scale on the watch.
If you have now selected the desired time zone using the seconds hand, press once the button at the bottom right (A) to confirm your choice.
The selected time zone is applied and the watch’s hands are now set to the relevant time of the day. If the signal is received daily
automatically, the time zone you have set manually will remain unchanged.
If you wish to return to your time of the day / time zone, follow the instructions as in Step B2.2.
D) Flight mode –Disable the automatic signal reception
Your GPS enabled wrist watch has a flight mode which, if set, disables the automatic signal retrieval function.
To activate the flight mode press the buttons (A) and (B) simultaneously for about 5 seconds.
The seconds hand will now rotate to the aircraft symbol. Thereafter, the seconds hand will rotate to its previous position of seconds. Any
automatic signal retrieval is now disabled. To disable the flight mode and to revert to the current GPS time, manually run a signal retrieval
operation / signal reception for the time of the day and the time zone as described in Step B2.2.
ENGLISH

Trend News Europe GmbH –Eichholzer Str. 3c –D-21436 Marschacht ENG GPS610c 09/15
3 / 3
E) Re-calibration of the GPS enabled wrist watch –correcting any errors
If errors or inaccuracies occur with regard to the functions of your GPS enabled wrist watch, it may be due to the fact that watch has
experienced severe shocks or it was exposed to a static charge. Such malfunctioning can be mostly rectified by re-calibrating the watch’s
hands. To do this, follow these instructions:
Pull out the crown of your GPS wrist watch into position 1.
Then, press the button at the top right (B) step by step to set the seconds hand exactly to 12:00 o’clock. Now rotate the crown to set the
minutes and seconds hands likewise exactly to 12:00 o’clock. When done, all 3 hands of the watch should be exactly at 12:00 o’clock.
Now press the crown back into 0 position. The watch’s hands rotate back into the last set time of the day. Once the seconds hand is running
normally at seconds pace, manually retrieve / receive the signal to set the time of the day and the time zone as in Step B2.2.
Once your watch is reset properly, all its functions should return to normalcy.
F) Table of time zones, shown on the rim of the Global Time Zones G) Explanation to dial
(selection of all time zones) (Symbols on the watch’s face)
This product complies with the EMV directives of the EU
Water Resistance as per DIN 8310
The water resistance specification of your watch is imprinted on its base and is in its new condition subject to following do’s and don’ts:
WR: Washing, Rain, Splashes = NO, Shower = NO, Bathing = NO, Swimming = NO, Diving without equipment = NO
3 Bar: Washing, Rain, Splashes = YES, Shower = NO, Bathing = NO, Swimming = NO, Diving without equipment = NO
5 Bar: Washing, Rain, Splashes = YES, Shower = NO, Bathing = YES, Swimming = NO, Diving without equipment = NO
10 Bar: Washing, Rain, Splashes = YES, Shower = NO, Bathing = YES, Swimming = YES, Diving without equipment = NO
Instructions for environmental protection
Disposal of old devices. At the end of its life, this product should not be thrown into the normal household waste, but must be handed over at a collecting point for recycling
electric devices. The appropriate symbol on the product or the User Guide indicates this accordingly. As per the markings, the materials are recyclable. By recycling the
materials or by other forms of recycling old devices you will be making a significant contribution to the protection of our environs. Please obtain more information about this
from the responsible waste disposal facilities of your community administrative authorities.
Dispose of used batteries in a proper way. Do not throw away the watch indiscriminately, but dispose of it environmentally correctly. Use appropriate collecting points or
special waste dumps for this purpose.
Disposal of packaging material. Packaging materials are raw materials and, therefore, recyclable. For the sake of environmental protection, please dispose of these properly.
Your community administrative authorities will gladly provide with more information.
Code
Time zone
Difference
(hours)
Code
Time zone
Difference
(hours)
SAM
Samoa
-11
RIY
Riyadh
+3
HNL
Honolulu
-10
TEH
Teheran
+3.5
ANC
Anchorage
-9
MOS
Dubai/Moscow
+4
LAX
Los Angeles
-8
KBL
Kabul
+4.5
DEN
Denver
-7
KHI
Karachi
+5
PHO
Phoenix
-7
DEL
Delhi
+5.5
CHI
Chicago
-6
DAC
Dhaka
+6
NYC
New York
-5
YGN
Rangoon
(Yangon)
+6.5
CCS
Caracas
-4.5
BKK
Bangkok
+7
SAN
San Juan
-4
BJS
Peking
+8
RIO
Rio de Janeiro
-3
TYO
Tokyo
+9
AZO
Azores
-1
ADL
Adelaide
+9.5
LON
London
UTC
0
SYD
Sydney
+10
BER
Berlin
+1
NOU
Noumea
+11
ATH
Athens
+2
AUC
Auckland
+12
ENGLISH