eDecks King Edward User manual

Step 1 FRAME TO BE LAID ONTO
PAVING SLABS, OR ONTO
GRASS OR SOIL
Using the decking joists provided in the Kit (100x50 mm) timber please proceed to build
the frame. Using the 4” x 10g screws to secure the timbers.
Please make sure the frame fits the requirements for your chosen kit.
Don’t forget to check your work with a level as you go! Page 1 of 7
METHOD FOR SCREWING
LAY YOUR FRAME
ANGLE SCREW
STRAIGHT FASTENING
This may require
some cutting to fit your size
requirements
This is an example of a decking frame
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

Please make sure your
post notches line Up
Additional posts may
be supplied depending
on size of your kit
Step 2
Don’t forget to check your work with a level as you go! Page 2 of 7
FITTING THE PERGOLA POSTS
You are supplied with 2 4M pergola
posts. Accounting for the post sitting
flush with the bottom of the base
please select how hight you would
like the pergola posts, please cut
accordingly.
Each Pergola Post needs securing in
each corner and depending on the
size of the kit posts may need fitting in
between.
Install posts your kit begins to look
like the below...
www.eDecks.co.uk
CARRIAGE
BOLT
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

Cutting will be
required around the
Posts
Deck boards 2x
fixings per joist
Step 3
Don’t forget to check your work with a level as you go! Page 3 of 7
INSTALL DECKING BOARDS
Decking boards should fit exactly to the frame, working in the
opposite direction to the joist work
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

Secure
Step 4
Don’t forget to check your work with a level as you go! Page 4 of 7
INSTALL SUPPORT RAFTERS
First secure the 2 supporting rafters to the posts.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

Step 5
Don’t forget to check your work with a level as you go! Page 5 of 7
INSTALL RAFTERS
Space the remainder of the rafters across
the top of the support rafters
www.eDecks.co.uk
Using the Pergola Clips
provided with your kit
to secure
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

125 mm Gap
between each spindle
Step 6
Don’t forget to check your work with a level as you go! Page 6 of 7
HANDRAIL SYSTEM
Pre-Building the spindles and handrails is the next step.
Accurately measure between pergola posts cut hand and base rails accordingly, there should be a 125mm gap between each spindle
Once your handrail sections are complete - using
angle brackets please proceed to install to the kit
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions

Step 7
Once this is complete - Sit back and enjoy! Page 7 of 7
FINISH!
This is an example of the finished pergola.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
King Edward Fitting Instructions