Eibach Springs AK41-213-001-01-20 User manual

D3824 www.eibach.com Page 1
Kit Contents Description Part Number Qty
End Link UEL10010113 2
Instructions AK41-213-001-01-20INST 1
NOTES: Read All Instructions Before Beginning Installation
Only qualified mechanics experienced in the installation and removal of suspension components should
perform this installation.
Use of a hoist and screw jack is highly recommended and will substantially reduce installation time.
Never work on or under a vehicle unless it is properly supported.
Removal and Installation of Eibach
adjustable end links.
1. Loosen and remove the hardware that secures the OE
end link to the end of the OE anti roll bar and the control
arm, then, remove the end link. (See Photos 1 & 2)
2. Adjust the Eibach end link to 160mm from center to
center as shown. Do not tighten the jam nuts at this
time. (See Photo 3)
Installation Instructions
Front End Link Kit # AK41-213-001-01-20
Eibach Springs, Inc. 264 Mariah Circle Corona, California 92879-1751 USA Tech Support 800-222-8811 Ext 114
Photo 1
Photo 2
Photo 3
Photo 4
160mm

D3824 www.eibach.com Page 2
3. Install the link and secure it to the bar and the control
arm with the provided hardware. (See Photos 4 & 5)
4. With the hardware properly secured and the ends
properly orientated, tighten the jam nuts as shown.
(See Photo 6)
5. Repeat this procedure on the opposite side.
6. Double check to make sure everything is properly
positioned and tightened, then, road test the vehicle.
7. After road testing, double check all hardware to make
sure everything is properly tightened and re-tighten if
necessary.
Photo 5
Photo 6