4. Technical data
mc1.05tnemecalpsidenignE 3
Maximum engine capacity 2.2 kW
mc44htgnelraB
)mc54(”81htgnelliarrettuC
Chain pitch (0.325”), 8.255 mm
Chain thickness (0.058”), 1.47 mm
mpr0023deepsgnildI
Maximum speed with cutting equipment 11000 rpm
lm055yticapacknaT
lm062yticapacknatliO
seYnoitcnufnoitarbiv-itnA
Chain wheel teeth 7 x 8.255 mm
seYekarbniahC
seYhctulC
Automatic chain lubrication Yes
seYniahckcabkcik-woL
Net weight without chain and chain bar 5.4 kg
gk7.6)yrd(thgiewteN
Fuel consumption (specific) 560 g / kWh
LpA sound pressure level 101 dB(A)
KpA uncertainty 2.5 dB(A)
LWA sound power level 114 dB(A)
KWA uncertainty 2.5 dB(A)
Vibration ahv (front handle) max. 6.6 m/s2
Khv s/m5.1ytniatrecnu 2
Vibration ahv (rear handle) max. 6.91 m/s2
Khv s/m5.1ytniatrecnu 2
Chain type Oregon 21BPX072X
Bar type Oregon 188PXBK095
FTR8LgulpkrapS
5. Before starting the equipment
Important: Do not start the engine until the saw
is fully assembled.
Important: Wear protective gloves at all times
when handling the chain.
5.1 Fit the chain bar
To ensure that the bar and the chain are supplied
with oil, USE ONLY THE ORIGINAL BAR. The oiling
hole (Fig. 2/Item A) must be kept clear of dirt and any
build-up of residue.
1. Make sure the Chain brake lever is pulled back
into the DISENGAGED position (Fig. 3A)
2. Remove the two bar fastening nuts (B). Remove
the cover (Fig. 3B).
3. Using a screwdriver, run the adjustment screw
(D) COUNTERCLOCKWISE until the TANG (E)
(projecting prong) is to the end of its travel toward
the clutch drum and sprocket (Fig. 3B/3C).
4. Fit the open end of the chain bar over the die bar
pins (F) (Fig. 3C/3D).
5.2 To install saw chain
1. Spread chain out in a loop with cutting edges (A)
pointing CLOCKWISE around loop (Fig. 4A).
2. Slip the chain around the sprocket (B) behind the
clutch (C). Make sure the links fit between the
sprocket teeth (Fig. 4B).
3. Guide the drive links into the groove (D) and
around the end of the bar (Fig. 4B).
NOTE: The saw chain may droop slightly on the lower
part of bar. This is normal.
4. Pull the chain bar forward until the chain is closely
seated. Make sure that all the drive links are in
the groove of the bar.
5. Fit the clutch cover and fasten it with 2 screws.
Make sure that the pivot (Fig. 3C/Item E) fits into
the chain bar (Fig. 3D/Item G). The chain must
not slip off the bar when you do this. Tighten the
two nuts by hand and then follow the instructions
for adjusting the tension in ADJUSTING THE
CHAIN TENSION.
10
GB
Anleitung_BG_PC_5045_SPK1:_ 26.10.2010 9:41 Uhr Seite 21
