Ekselans PIR-2 User manual
1
PIR-2
Wireless Pet-immune Motion Sensor
User manual
2
Features
The wireless pet-immune motion sensor is an accessory of smart alarm
system. It accurately detects human
body movement and eectively avoids false alarms caused by pets. Featu-
red with automatic temperature
compensation technology, it ensures high intelligence, sensitivity, and sta-
bility. It has modern and elegant
appearance. With the technology like energy saving and low battery war-
ning, it is easy to setup and use.
Parameters
Reference PIR-2
Code 261024
Wortking voltage DC 9V
Battery 2xAA (1,5V)
Working current < 15mA
Standby current < 25µA
Detective range 100°
Detective distance 12mx12m
Inmunity of pets < 20Kgr
Transmission distance Without obstacle 200m
Transmission frequency 433,92MHz
Working Temperature -10°C ~ 50°C
Humidity < 90% (non-condensing)
Dimension 99,6x54,9x40,2mm
Weight 66g (battery not included)
112g (battery included) 62.3g(bracket)
3
Appearance
PCB layout
Bracket
Magnetic slice
LED Indicator
Infrared
Sensor
Detective
Interval Time
Setting Switch
(every 5s. or 5min.)
4
Operating Instructions
1. Working principle
with digital dual-core fuzzy logic operative programming and intelligent analysis, it
accurately detects human body movement with infrared sensor and sends signal to
main panel.
2. Pairing with main panel by App
- Scan the QR code printed on the sensor.
- The pairing result would be confirmed in App.
3. Product testing
- Power on, LED indicator would flash for 1s.
- It takes about 30s for self-check.
Installation & Notice
• Open the case and remove the battery insulating strip.
• Pairing it with main panel by App before installing.
• Fix the bracket with screws on wall, connect the sensor
to bracket, adjust a proper angle.
• Recommended to install at height of 1.8-2.4m from
ground.
• Make sure there is no inducement for pet to pass by,
like stair and etc.
• Avoid installing the sensors in area of our door, air-con-
dition nearby, direct sunshine, heat source and under
the rotating objects.
• Please install and use the sensor according to this
manual, don’t touch the surface of sensor for avoiding
aecting the sensitivity of the sensor. Please shut o
power and then clean the sensor by soft cloth with little
alcohol if cleaning needed.
• In order to ensure normal work, the power should be
kept to supply and get on walking test periodically, once
a week is better.
↑Vista de detección de la zona
(vista superior)
Detecting Area View
(side view)
Detecting Area View
(top view)
5
Battery Replacement Instructions
If the LED indicator stays on, please replace the battery.
1. Press down the
hook on sensor with
thumb pushing on it
to open the cover.
2. Replace with 2x AA
battery.
6
EKSELANS by ITS
ITS Partner O.B.S. S.L
Av. Corts Catalanes 9-11
08173 Sant Cugat del Vallès
Barcelona (Spain)
Tel: +34 935839543
www.ek.plus
This manual suits for next models
1
Table of contents
