ELARABY TORNADO TKSE-40771 User manual
ﻰﻧوﺮﺘﻜﻟا ﻞﻴﺗﺎﻛ
ﻞﻴﻐﺸﺘﻟا ﻞﻴﻟد
ﻰﺑﺮﻌﻟا ﺔﻛﺮﺸﺑ ﺔﺻﺎﺧ ﺔﻠﺠﺴﻣ ﺔﻳرﺎﺠﺗ ﺔﻣﻼﻋ ﻰﻫ وﺪﻴﻧرﻮﺗ ﺔﻣﻼﻌﻟا هﺬﻫ
ﻞﻳدﻮﻣ
وﺪﻴﻧرﻮﺗ - ﻰﻧوﺮﺘﻜﻟا ﻞﻴﺗﺎﻛ كرﺎﻴﺘﺧﻹ ًاﺮﻜﺷ
TKSE-40771
2
3
4
---
--
LED
LED.
.
LED
MINMAX
5
LED
6
LED
7
8
8
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to an
appropriate waste disposal center.
7
Cleaning And Maintenance
Removal Of Mineral Deposits
Always disconnect the appliance from the power outlet and cool
it down completely before cleaning.
1. Never immerse the kettle,power cord and power base in any
liquids, and allow moisture to contact with these parts.
2. Wipe the appearance of body with a damp cloth or cleaner,
never use a poisonous cleaner.
3. Remember to clean the filter at intervals. For easier cleaning,
detach the filter and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners
to clean the outside of the kettle to prevent the gloss loss.
4. When not use or storage, the power cord may be wind under
the bottom of kettle.
Your kettle should be periodically descaled as the mineral
deposits in tap water may form scale at the bottom of kettle
interior so as to cause the operation less efficiency. You can use
the commercially available descaler and follow the instructions
on the package of descaler. Alternatively, you may follow the
below instructions to use the white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then adding water to
the amount so as to cover the bottom of kettle completely. Leave
the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then filling the kettle with
clean water, boiling and then discard the water. Repeat several
times until the odor of vinegar has been flushed away. Any stains
remaining inside the spout can be removed by rubbing with a
damp cloth.
6
Using Your Water Kettle
Using Your Water Kettle
NOTE:
1) The kettle will reheat the water to the preset temperature and
then stop heating if the water temperature is 5°C lower than the
preset temperature during keeping warm
process. For example, if the preset temperature is 70°C, the kettle
will reheat the water to 70°C and then stop heating if the water
temperature is lower than 65°C during keeping warm process.
2) You can press “ ” button or “ ” button to make the kettle
stop keeping warm during keeping warm process.
3) Under keeping warm condition, remove the kettle from the
power base for more than 3 minutes, then replace the kettle on the
power base, the appliance will continue keeping warm based on
the preset temperature. Hold and press “ ” button for 2 seconds,
the appliance will enter into sleep mode, and you can press any
button to make the appliance enter into standby mode.
7. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle
as boiling water may result in scald, besides, don’t open the lid
while the water in the kettle is hot.
8. The kettle may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
If the kettle operate without water accidentally, when
temperature sensor detects temperature exceed 105°, the kettle
will stop heating, meanwhile all of LEDs will blink for warning, if
this occurs, allow the kettle to cool before filling with cold water
to re-boil.
5
Using Your Water Kettle
3. Plug into the power outlet, the light bar blinks.
4. Position the kettle on the power base, the light bar and the
indicator of 100°light up.
5. At that time, if you do not want to select the preset temperature,
you can press “ ” button directly, then the kettle starts heating,
and it will boil the water to 100°C . During heating process, the
indicator of 100°C, the indicator of On/Off button and the light bar
keep illuminating. When the kettle finish heating, one beep can
be heard and the kettle will stop working automatically.
NOTE:
1) You can press “ ” button to make the kettle stop heating
during heating process.
2) The appliance will enter into seelp mode if remove the kettle
from the power base or no any operation for more than 3 minutes
during heating process,at that time, replace the kettle on the
power base and press any button, then the appliance will enter
into standby mode.
3) Hold and press “ ” button for 2 seconds, the appliance will
enter into sleep mode, and you can press any button to make
the appliance enter into standby mode.
6. And you can select the preset temperature by the
“Temperature preset button”. There are “70°” or “80°” and“90°” for
selection. After select the preset temperature, its corresponding
indicator illuminates, and then press “ ” button, the kettle starts
heating. When boiling the water to the preset temperature,
one beep can be heard, and the kettle will stop heating and
enter into keep-warm mode automatically. Then the kettle will
keep warm for 30 minutes. The selected preset temperature
indicator, the indicator of Keep-warm button and light bar keep
illuminating during keeping warm process. After finish keeping
warm, all the LEDs turn off and the appliance enters into sleep
mode, then you can press any button to make the appliance
enter into standby mode.
4
Control Panel Introduction
Before Using Your Kettle
Using Your Water Kettle
Buttons: “ ”, “70°”, “80°”, “90°” , “100°” and “ ”, total 6 buttons.
Instruction:
Temperature preset button: for presetting the keep-warm temperature (it
can choose 70°,80°,90°,3 options). 100°only for boiling.
“ ” button: for cancelling the keep-warm function.
Display: LED indication
Display instruction:
1. Sleeping model: all of the LEDs turn off;
2. Standby mode:
2.1: Kettle being on the base, indicator of 100°and light bar are lighting;
2.2: Without kettle on the base, light bar blinks (once per second), other LEDs
turn off;
3. Working mode: Corresponding selected temperature indicator, indicator
of On/Off button and light bar are lighting;
4. Keep-warm mode: Corresponding selected temperature indicator,
indicator of Keep-warm button and light bar are lighting, while the indicator
of On/Off button turns off.
If you are using the kettle for the first time, it is recommended that you
should clean your kettle before use by boiling a full kettle of water twice
and then discarding the water. Wipe the surface with a damp cloth.
NOTE: The max capacity of kettle is 1.7L.
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and open the lid
by pressing the lid release button, then fill the kettle with the desired
amount of water, and close the lid. Alternatively, the kettle may be filled
through the spout. The water level should not exceed MAX marks or sit
below MIN level. Too little water will cause the kettle switching off before
the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill
out of the spout when boiling. Ensure that the lid is firmly in place before
plugging the power outlet.
3
Important Safeguards
Know Your Water Kettle
22. Unplug the kettle from the outlet when not in use and before
cleaning. Allow the kettle to cool before putting on or taking off
parts, and before cleaning the appliance.
23. To disconnect, turn any control to “off,” then remove plug from
wall outlet.
24. Do not use the appliance for other than intended use.
25. Always ensure the lid is closed and do not lift it while the
water is boiling. Scalding may occur if the lid is removed during
the brewing cycles.
26. Do not use outdoors.
27. This appliance is intended to be used in household and similar
applications such as:
– Staff kitchen areas in shops, offices and other working
environments;
– Farm houses;
– By clients in hotels, motels and other residential type
environments;
– Bed and breakfast type environments.
28. Save these instructions.
Lid
Spout
Bady
ON/OFF
Button
warm
Button
Light Bar
Power
Base
Handle
Temperature
preset button
Lid Release
Button
Water Gauge
2
1. Read all instructions before using.
2. Before connecting the kettle to the power supply, check that the
voltage indicated on the appliance (underside the kettle & base)
corresponds with the voltage in your home. If this is not the case, contact
your dealer and stop using the kettle.
3. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
4. Do not let the cord hang over the edge of a table or counter or touch a
hot surface.
5. Do not place on or near a hot gas or electric burner or in a heated oven.
6. Do not operate the appliance without anything in it to avoid damaging
the heat elements.
7. Ensure that the kettle is used on a firm and flat surface out of reach of
children, this will prevent the kettle from overturning and avoid damage
or injury.
8. To protect against a fire, electric shock or personal injury, do not
immerse cord, electric plugs or kettle in water or other liquids.
9. While water is boiling, or just after the water has been boiled, avoid
contacting with steam from the spout.
10. Always take care to pour boiling water slowly and carefully without
tipping the kettle too fast.
11. Be careful of refilling when the kettle is hot.
12. If the kettle is overfilled, boiling water may be ejected.
13. Do not touch the hot surface. Use the handle or the button.
14. The kettle is only to be used with the stand provided.
15. Insure that the kettle is switched off before removing it from its stand.
16. The appliance must not be immersed.
17. Extreme caution must be used when moving an appliance containing
hot water.
18. Appliances can be used by persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance in
a safe way and they understand the hazards involved.
19. This appliance can be used by children aged from 8 years and above
if they have been given supervision or instruction concerning use of
the appliance in safe way and if they understand the hazards involved.
Cleaning and user maintenance shall not be made by children unless
they are older than 8 and supervised. Keep the appliance and its cord
out of reach of children aged less than 8 years.
20. Children shall not play with the appliance.
21. The use of accessories, which are not recommended by the appliance
manufacturer, may result in fire, electric shock or personal injury.
Important Safeguards
Temperature Control Kettle
TKSE-40771
Thanks for Choosing Tornado
Temperature Control Kettle
Table of contents
Languages:
Popular Kettle manuals by other brands
Makita
Makita GTK01 instruction manual
Metos
Metos PROVENO S 40 l Installation and operation manual
Electrolux
Electrolux EEWA5310 Instruction book
Stirling
Stirling Vintage JK-115F-BLK quick start guide
CASO DESIGN
CASO DESIGN Classico WK 2200 Original operating manual
BREWISTA
BREWISTA Stout Spout BSS12VTK Series manual
