Electro-Voice FMK User manual

General Description
The FMK flange mount kit is a permanent mounting
accessory for the CP212 and CP218 podium microphone.
The kit consists of a mounting flange, washer, nut, and
three set screws, and is designed for installation into panel
up to 3/4-inch thick,
Mounting a CP212 or CP218 is quick and easy using the
FMK mounting kit.
Installation
1. Select the microphone location by first checking for
obstructions under the panel that will interfere with the
microphone and for a flat surface to properly seat the
washer and retaining nut. Panel thickness may not
exceed ¾ inch.
2. Drill a 1 1/8-inch hole at the microphone location.
3. Set the roll-off switch on the microphone to the desired
response.
4. Insert the microphone into the fixed mount adapter;
secure by tightening the three set screws.
5. Insert the adapter into the drilled hole; secure this
assembly with panel washer and retaining nut. Do not
over-torque the retaining nut. Attach the microphone
connector. For depth restrictions, a right angle audio
connector may be required.
Warranty
Electro-Voice Accessories are guaranteed for one year from
date of original purchase against malfunction due to defects
in workmanship and materials. If such malfunction occurs,
unit will be repaired or replaced (at our option) without charge
for materials or labor if delivered prepaid to the proper
Electro-Voice service facility. Unit will be returned prepaid.
Warranty does not extend to finish, appearance items or
malfunction due to abuse or operation under other than
specified conditions, nor does it extend to incidental or
consequential damages. Some states do not allow the
exclusion or limitation of incidental or consequential
damages, so the above exclusion may not apply to you.
Repair by other than Electro-Voice or its authorized warranty
service agencies will void this guarantee.
A list of authorized service representatives is available from
EVI Audio Service at:
12000 Portland Ave. South,
Burnsville, MN 55337
Phone: [phone]
Fax: [phone]
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Specifications subject to change without notice.
Model FMK
Flange Mount Kit
Step Up To
RR
RR

12000 Portland Avenue South, Burnsville, MN 55337
Phone: [phone], Fax: [phone]
www.electrovoice.com
©Telex Communications, Inc. 2003
Part Number 531646, Rev B
U.S.A. and Canada only. For customer orders, contact the Customer Service department at:
800/392-3497 Fax: [phone]
Europe, Africa and Middle East only. For customer orders, contact the Customer Service department at:
49 9421-706 0 Fax: [phone]
For Warranty information, contact the Service Repair department at:
402-467-5321 or 800-553-5992
For technical assistance, contact Technical Support at: 800-392-3497
*Specifications subject to change without notice