Electro-Voice UW30 User manual

UW30
UW30-100
Underwater
Loudspeaker
General Product Description
The UW30 represents a departure in the design of
underwater sound sources. Its unique design, U.S. Patent
#3,670,299, utilizes the case’s structural enclosure as the
sound transducer. This development makes possible a
speaker that has no metal parts exposed to the outside,
thus eliminating rust, corrosion or other causes of short-life
expectancy. The transducer principle and its strong
construction allow the UW30 to operate at much greater
depths than any prior type of underwater loudspeaker design.
The 12.7-ounce ceramic magnet and state-of-the-art
voice-coil construction ensure full-fidelity response with the
lowest possible distortion throughout its power range.
The UW30 is equipped with a waterproof, 3 conductor 15.24
m (50-ft.) cable. The UW30-100 features a 30.48 m (100 ft.)
cable.
The UW30 underwater loudspeaker is designed for
permanent installation and completely submerged operation.
All internal components are encapsulated with a “hot-melt”
(Polyamide Copolymer) process. The outer case is
constructed of high impact ABS (Acrylonitrile butadiene
styrene) plastic. Ideal for installation in both fresh and
saltwater pools, the UW30 can even be installed in ocean
environments without adverse effect. Problems such as
corrosion and electrolysis damage inherent in all or partial
metal underwater speakers are completely eliminated by the
plastic construction of the UW30.
A single model UW30 will deliver uniform sound throughout
moderate pools, up to 30 by 30 feet. For larger pools, up to
30 by 60 feet, two speakers should be used. If a high level of
turbulence is to be overcome, such as swimming and diving
instruction classes, several speakers should be used. The
noise level in the water will not only be more effectively
overcome, but it will also allow each speaker to be operated
at a lower power level thus avoiding excessive sound
intensities in the immediate vicinity of the speakers.
Underwater speakers are required equipment for many
activities in commercial and luxury resort pools. As specified
by the American Athletic Union, underwater speakers are
required for synchronized swimming events and instructions
in Olympic pools. They are used for water ballets and similar
water shows. When underwater speakers are installed in
resort and private pools, the effect of music played
underwater is truly an enchanting experience.
Specifications:
Versions Available:
UW30 ................................. 50 feet of cable (15.24 m)
UW30/100 ........................ 100 feet of cable (30.48 m)
System Type: ............................ Underwater loudspeaker system
Frequency Response: ......................................... 100-10,000 Hz
Power Handling, (500-5,000 Hz pink noise): ................ 30 watts
Impedance: ....................................................... Nominal: 8 ohms
Dispersion: ....................................... Omnidirectional underwater
COMMERCIAL
Architects’ and Engineers’ Specifications
The underwater loudspeaker shall be the UW30. The case
shall be composed of color impregnated, shatterproof ABS
plastic. Speakers shall not be subject to damage or corrosion
from concentrations of chlorine, acid conditions, electrolysis,
saltwater or ocean environments and such minerals that may
be in solution or suspension in such waters. Frequency
response shall be 100 - 10,000 Hz, and impedance shall be
at 8 ohms. Power-handling capacity shall be 30 watts
continuous pink noise and dispersion shall be
omnidirectional underwater. Operating depth shall be not
more than 10 feet below the surface of the water.
Recommended operating depth for optimum efficiency shall
be not more than 1.2 m (4.0 ft.). The UW30 loudspeaker
shall be equipped with a 15.24 m (50 ft.), 3 conductor
waterproof cable terminated within the internal encapsulation
material. The UW30-100 features a 15.24 m (100 ft.) cable.
Case diameter shall be 182.6 mm (7.19 in.), and depth shall
be 6.63 mm (2.61 in.). Six 5.54 mm (0.218 in.) holes on a
169.7 mm (6.68 in.) circle shall be provided for mounting.
Speaker may be mounted in a wet-niche. Finish shall be
pool blue. Shipping weight shall be 1.8 kg (4.0 lb).
Operating Depth: ... Up to 3.0 m (10.0 ft) below surface of water
Recommended Installation Depth: ........................1.2 m (4.0 ft)
Finish: ............................................................................ Pool blue
Dimensions,
Overall Diameter: .......................... 182.6 mm (7.19 in.)
Depth: .............................................. 66.3 mm (2.61 in.)
Shipping Weight: .................................................... 1.8 kg (4.0 lb)

© Telex Communications, Inc. 02/2001
Part Number 38109-847 Rev A
U.S.A. and Canada only.
For customer orders, contact the Customer Service department at
800/392 3497 Fax: [phone]
For warranty repair or service information, contact the Service
Repair department at 800/685 2606
For technical assistance, contact Technical Support at 866/78 AUDIO
Please refer to the Engineering Data Sheet for warranty information.
Specifications subject to change without notice.
Installation
Flush Mounting
For new pool construction and modification of older pools, installing
the UW30 flush with the sides of the pool makes a very neat and
unobtrusive installation. The speaker is mounted in a wet-niche
(Paragon Part #68102 or equivalent) in the same manner as an
underwater light. Figure 1 shows a typical installation. The speaker
is mounted up to 1.2 m (4 ft.) below the surface of the water and
flush with the side of the pool. (For installation in water depths lower
than recommended, please contact factory.) A marine plywood or
stainless steel mounting ring or face plate is recommended.
(Paragon Part # 6810355 stainless steel or #68103 bronze polished
chrome or equivalent). Several pool equipment manufacturers have
wet-niches available into which the UW30 may be installed. See
your local pool supplier for further information. You may contact
Paragon at: KDI Paragon, Inc., 341 Route 55 Westwing,
LaGrangeville, NY 12540, Phone: [phone]
Fusing
For maximum protection against speaker overload, fusing the line
from the amplifier is recommended. In the event of accidental
overload, it is much easier to replace a fuse (which is above the
water) than to replace or have the speaker repaired. Installing a 25
ohm, 20 watt resistor in parallel with a 1.5 ampere, fastblowing
fuse in series with the speaker is recommended. See Figure 2.
Layout of Speaker in Pool
When underwater speakers are installed, particularly in smaller
pools where only one or two speakers are needed, they should be
located in the deep end of the pool. The above recommendation
will effectively equalize the intensity of sound throughout the pool.
For installations in large pools, such as at country clubs, municipal
facilities, etc., the speakers should be located around the periphery
of the pool. A good rule to follow for large pools is one speaker for
every 900 square feet (83.61 square meters) of pool surface at the
deep end and one speaker for every 1,200 square feet (111.48
square meters) of pool surface for the shallow end. Of course, for
high-noise conditions in the pool, the number of speakers should
be doubled for best results.
Figure 1
Typical Installation of a KDI Paragon Wet-Niche #68102
Figure 2
Fuse Recommendation
Figure 3
UW30 / UW-100 Dimensions
USA 12000 Portland A e South, Burns ille, MN 55337, Phone: [phone], FAX: [phone]
Canada 705 Progress A enue, Unit 46,Scarborough, Ontario, Canada, M1H2X1,Phone: [phone], FAX: [phone]
Switzerland Keltenstrasse 11, CH-2563 IPSACH, Switzerland, Phone: [phone]. FAX: [phone]
Germany Hirschberger Ring 45, D94315, Straubing, Germany, Phone: [phone], FAX: [phone]
France Parc de Courcerin, Alle Lech Walesa, Lognes, 77185 Marne La Vallee, France, Phone: [phone], FAX: [phone]
Australia Unit 23, Block C, Slough Business Park, Slough A enue, Sil erwater, N.S.W. 2128, Australia, Phone: [phone], FAX: [phone]
Hong Kong Unit E & F, 21/F, Luk Hop Industrial Bldg., 8 Luk Hop St., San PO Kong, Kowloon, Hong Kong, Phone: [phone], FAX: [phone]
Japan 2-5-60 Izumi, Suginami-ku,Tokyo, Japan 168, Phone: [phone], FAX:[phone]
Singapore 3015A Ubi Rd 1, 05-10, Kampong Ubi Industrial Estate, Singapore 408705, Phone: [phone], FAX: [phone]
Mexico A . Parque Chapultepec #66-201, Col. EI. Parque Edo. Mex. 53390, Phone: [phone], FAX: [phone]
UK 4, The Willows Centre, Willow Lane, Mitcham, Surrey CR4 4NX, UK, Phone: [phone], FAX: [phone]
Africa, Mid East 12000 Portland A e South, Burns ille, MN 55337, Phone: [phone], FAX: [phone]
Latin America 12000 Portland A e South, Burns ille, MN 55337, Phone: [phone], FAX: [phone]
www.electrovoice.com • Telex Communications, Inc. • www.telex.com