Electrolux EFC60001 User manual

USER MANUAL
EFC60001
EFC70001
EFC90001

We were thinking of you
when we made this product

electrolux 3
RECOMMENDATIONS AND SUGGESTIONS 5
CHARACTERISTICS 6
INSTALLATION 8
USE 11
MAINTENANCE 12
EN
Welcome to the world of Electrolux
Thank you for choosing a rst class
product from Electrolux, which hopeful-
ly will provide you with lots of pleasure
in the future. The Electrolux ambition is
to offer a wide variety of quality prod-
ucts that make your life more comfort-
able. You nd some examples on the
cover in this manual. Please take a few
minutes to study this manual so that
you can take advantage of the benets
of your new machine. We promise that
it will provide a superior User Experi-
ence delivering Ease-of-Mind.
Good luck!
EN

4 electrolux Recommendations and Suggestions
EN
Installation
• The manufacturer will not be held li-
able for any damages resulting from
incorrect or improper installation.
• The minimum safety distance be-
tween the cooker top and the extrac-
tor hood is 650 mm.
• Check that the mains voltage corre-
sponds to that indicated on the rating
plate xed to the inside of the hood.
• For Class I appliances, check that the
domestic power supply guarantees
adequate earthing.
Connect the extractor to the exhaust
ue through a pipe of minimum diam-
eter 120 mm. The route of the ue
must be as short as possible.
• Do not connect the extractor hood to
exhaust ducts carrying combustion
fumes (boilers, replaces, etc.).
• If the extractor is used in conjunction
with non-electrical appliances (e.g.
gas burning appliances), a sufcient
degree of aeration must be guaran-
teed in the room in order to prevent
the backow of exhaust gas. The
kitchen must have an opening com-
municating directly with the open air in
order to guarantee the entry of clean
air.
Use
• The extractor hood has been de-
signed exclusively for domestic use to
eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has ben de-
signed.
• Never leave high naked ames under
the hood when it is in operation.
• Adjust the ame intensity to direct it
onto the bottom of the pan only, mak-
ing sure that it does not engulf the
sides.
• Deep fat fryers must be continuously
monitored during use: overheated oil
can burst into ames.
• Do not ambè under the range hood;
risk of re
• The hood should not be used by chil-
dren or persons not instructed in its
correct use.
Maintenance
• Switch off or unplug the appliance
from the mains supply before carrying
out any maintenance work.
• Clean and/or replace the Filters after
the specied time period.
• Clean the hood using a damp cloth
and a neutral liquid detergent.
The symbol on the product or on
its packaging indicates that this product
may not be treated as household waste.
Instead it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropriate
waste handling of this product. For more
detailed information about recycling of this
product, please contact your local council,
your household waste disposal service or
the shop where you purchased the product.
RECOMMENDATIONS AND SUGGESTIONS

Characteristics electrolux 5
EN
Dimensions
CHARACTERISTICS
















��
 

��
��
670
670 min
920 max
Components
Ref. Q.ty Product Components
F1 Adapting ring ø 120-125 mm
G1 Reducer Flange ø 150-120 mm
H1 Air Outlet Connection
Ref. Q.ty Installation Components
C2 Upper Chimney Section Fixing
Brackets
Q.ty Documentation
1 Instruction Manual





6 electrolux Installation
EN
INSTALLATION
The cooker hood must be installed cen-
trally over a cooking appliance. The mi-
nimum distance between the cooking
surface and the metal grease lters on
the underside of the hood must be at
least 650mm.
To install the hood proceed as follows:
1) Drill six 8mm diameter holes at X1-
X2-J and insert the plastic rawl plugs
supplied as illustrated ensuring the
brackets are tted as shown in the
blow up.
2) Secure the two brackets C to the wall
inserting two of the screws supplied
through the two holes on line X1-X2
as illustrated .
3) Slide the canopy down the wall to
locate the key hole over the washer
then secure the canopy to the wall
by inserting two of the screws sup-
plied through the two outer holes in
the rim of the canopy J1 and J2 as
illustrated
















��
 

��
��







�



670
920 max
670 min

Installation electrolux 7
EN
Connections
Connection in Extraction Mode
When installing in extraction mode, con-
nect the hood to the chimney using ei-
ther a exible or rigid pipe ø 150 or 125
mm, the choice of which is left to the
installer.
• To install a ø 125 mm air exhaust con-
nection, insert the reducer ange G
on the hood body air outlet and the
adapting ring ø120-125 Fon the re-
ducer ange.
• Fix the pipe in position using sufcient
pipe clamps (not supplied).
• Remove any activated charcoal l-
ters.
Connection in Recirculation Mode
• When the hood is tted in the recircu-
lation mode the Air Outlet Connection
H should be tted as illustrated .
• Fit the (optional) charcoal lters by
repeating the following operation on
each side of the motor housing. Place
the two key hole slots in the lter and
turn the lter clockwise to lock the
lter in position.
WARNING: It is a possible re hazard if
the metal grease lters are not cleaned
and the charcoal lters replaced regu-
larly.
IMPORTANT:
When installing this product in recircula-
tion mode over a gas hob or Gas coo-
ker and between adjacent wall mounted
cupboards. The installer must ensure
that there is no gap between the edge
of the canopy and wall cup-boards.







H
A
B

8 electrolux Installation/Use
EN
Chimney assembly
Upper Chimney
• To t the upper chimney A, place the
top edge of the chimney over the
bracket C as illustrated and secure
the chimney using two of the 2.9mm
self tapping screws provided.
• The distance H in the height between
the xing holes X1 and X2 is deter-
mined by the height of the upper
chimney A.
Lower Chimney
• To t the lower chimney B, apply slight
force to the two rear edges to increase
the width of the apperture, then sleeve
the chimney B over the chimney A as
illustrated.

�
Connection to the Mains
WARNING: Double insulated do
not earth
• Before connecting to the mains sup-
ply ensure the mains voltage corre-
sponds to the voltage on the rating
plate inside the hood.
• This appliance is tted with a 2 core
mains cable and must be permanently
connected to the electricity supply via
a double-pole switch having 3mm
minimum contact gap on each pole.

Maintenance electrolux 9
EN
USE
The cooker hood functions are control-
led by a series of slider or push button
switches mounted on the front of the
hood and control the worktop lighting
and fan motor speeds. This cooker
hood will not remove steam.
1) SLIDER SWITCHES
- A switch controls the wotktop light-
ing - ON/OFF.
- A switch controls the fan speeds -
OFF/ON-1-2-3.
- The red neon lamp illuminates when
the motor is switched ON .
2) SPEED SETTINGS
- 1/Low should be selected when
simmering or when using only one
pan.
- 2/Medium should be selected for
cooking when using up to four
pans.
- 3/High should be selected when
frying or cooking food with a strong
odour.

MAINTENANCE
N.B. Before carrying out any kind of
maintenance, cleaning or replacing lam-
ps, disconnect the hood from the mains
supply.
Lighting
40 W incandescent light
• Remove the metal grease lters. Dis-
connect the cooker hood from the
mains supply.
• Unscrew the bulbs and replace them
with new ones having the same char-
acteristics.
• Replace the metal grease lters.
Filters
• The metal grease lter should be
cleaned every two months or more
frequently if the hood is used consist-
ently and can be cleaned in a dish-
washer or by hand using a mild deter-
gent or liquid soap. When replacing,
ensure that they are dry.
• The charcoal lter cannot be washed
and should be replaced at least every
2 months or more frequently if the
hood is used consistently.
Cleaning
When cleaning the hood, it is recommended
to use a damp cloth and mild liquid house-
hold
cleaner. Never use abrasive cleaning mate-
rials.
ATTENTION: The manufacturer declines all
responsibility for any damage or injury
caused as a result of not following the in-
structions for installation, for maintenance
and replacement times of lters indicated (in
order to avoid a possible risk of re when the
lters are saturated with grease).