Electrolux EWT654XW User manual

INSTALLATION INSTRUCTIONS
16
1.Unpacking and bottom cover
1.1 Take the machine out of the
packaging base.
1.2 After lifting the machine out,
all the packaging base must be
removed.
Motor Base
Polystyrene Base
2.Bottom cover insertion
Corner
Packing
Bottom Cover
Inlet hose and Drain hose
are placed under the top
polystyrene.
3. Drain hose
3.1 Holding the hose clamp and
squeezing it, then put it into the
drain hose inserting.
3.2 Insert drain hose into the drainage
holes at the bottom of washing
machine until it comes to end.
Squeeze hose clamp again and
shift it to the location as shown
on picture to lock the drain hose.
IMPORTANT :The top polystyrene
must be removed the last process,
protecting the drum from hitting the
cabinet when the machine is tilted.
Lay down the machine on its back
side, and insert the bottom cover
into slot until to the end, then fasten
the screw.
IMPORTANT :Prevention damaged to
the cabinet by placing two of the corner
packing pieces supporting between
back of machine and floor.
IMPORTANT:
Top polystyrene must be removed after
installation bottom cover.
Lift up the machine and remove the top
polystyrene.

INSTALLATION INSTRUCTIONS
17
3.3 Position drain hose by adjusting
the free length of hose to suit
your installation.
IMPORTANT:
Do not put hose tip
into the water. For
prevent syphon effect.
3000 mm.
100 mm.
MAX
MAX
4. Inlet hose
At the water tap faucet
4.1 Press the lower end of the lock
lever and push down the slider.
Take off the water inlet hose
jointer from the water inlet hose
component.
4.2 Loosen the screw till the water
faucet can be accessed. Put the
jointer of the water inlet hose on
the faucet.
4.3 Fasten the four screws evenly.
At the washing machine
4.4 Fix the lock nut on the water inlet
valve by even strength. Do not twist
water inlet hose to avoid breakage.

INSTALLATION INSTRCTIONS
18
5. Leveling of the machine
Machine should be placed even on
the floor. If the flooring is not even,
adjust the adjustable feet of the
washing machine until the entire
machine is stable.
IMPORTANT: Adjustable feet are
assembled on the left or right side
depending on the different models.
The left
Adjustable
feet model
EWT754XS
EWT754XW
The right
Adjustable
feet model
EWT854XS
EWT854XW
6. Lid and machine clearance
Machine must have at least 5 cm
space clearance around itself.
L
7. Control panel protective film
Protective film on the control panel can
be removed by yourself.
Protective film
Model W D H L
EWT754XW 560 575 950 1232
EWT754XS 560 575 950 1232
EWT854XW 580 600 950 1294
EWT854XS 580 600 950 1294
Product Dimension (mm.)
EWT654XW
EWT654XW 530 550 920 1218