Elegant Furniture And Lighting MRE8003 User manual

IF IN DOUBT ABOUT FITTING THIS PRODUCT, PLEASE CONSULT A QUALIFIED ELECTRICIAN
Page 1
USER GUIDE LED LIGHTED CABINET
USER GUIDE ? LED LIGHTED MIRROR
Elegant Furniture And Lighting Inc.
MRE8003
19.5x27.5x5.5 inch

C O M P O N E N T PA R T S AND F I T T I N G S
Safety Warning
Screw & Wall plug x 5
(Included in pack)
IMPORTANT
PLEASE READ THE INSTRUCTIONS BEFORE SET UP AND INSTALLATION
Cabinet x1
Suggested Tools:
Drill
Screw driver
Hinge cover x 2
(Included in pack)
M04
Wire nut x 3
(Included in pack)
M05
M07
M12
Glass shelf x 2
L shape bracket x 1
(Included in pack)
Mounting bracket x 1
(Included in pack)
(Included in pack)
Screw x 2
(Included in pack)
M13
M14
M15
Caution:
Safety:
• We suggest you spend a short time reading the instruction leaflet.
• Carefully check that you have all the parts before beginning assembly.
• Keep small parts and fittings out of children's reach and keep children well away from construction
area, as the unassembled product contains small parts, which could present a choking hazard.
• We suggest you retain these instructions for future reference.
• This appliance can be used by adults ONLY.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• In order to avoid overheating, do not cover the mirror.
• Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation
• Make sure that there is no danger that the cord or extension cord is inadvertently be pulled or cause
anyone to trip when in use.
Page 2
• Note that this is a hardwired installation and does not come with a power switch. Your electrician
must install the hardwired mirror to an electrical junction box to connect to a room light switch to
turn off or turn on the mirror.
Note that this mirror does not come with a dimmer.

STEP1. Mark the position of the hanging screw. STEP2. Fix the screw.
Page 3
STEP3. Contact the wires.
STEP4. Hang up the cabinet on the wall
Assembly User Instruction/
Cable outlet
Please read all instructions carefully.Before you proceed to install,make sure that the power supply is
turned off and remains off until installation is complete.
Please note that each part has been assigned a number and proceed in a numerical order.
M13

Page 4
Assembly User Instruction/
Notes:
Be careful not to over
loosen screw
If the square screw nut lost,
you could find spares in
fixings bag.
.
Fixing the glass shelves Adjusting the glass shelves
Fixing Glass Shelf Brackets
Door Adjustment
Loosen the rubber
plugs of the glass
shelf bracket, then
put the glass shelf
into the brackets,
tighten the plugs to
fix the shelf.
Turn the assigned screw clockwise can move
the mirror door towards the cabinet;
Turn the assigned screw counterclockwise
can move the door away the cabinet.
Turn the assigned screw clockwise can move
the mirror door right;
Turn the assigned screw counterclockwise can
move the door left.
Hinge Adjustment
Hinge cover
M04
Screw L shape bracket into place on the wall
and into the base of the cabinet. But do not
screw too tight for the base.
M15
M14
Tips: If the cabinet was fitted well with
mounting bracket (M13),no movement
left&right or away&towards the wall,it
is suggested not to fit the L shape
bracket (M14).

Installation Dimensions:
Elegant Furniture And Lighting Inc.
500 550 E.Erie Avenue philadelphia, PA 19134 -
Toll Free: 1 888 388 3390 Tel: [phone] - - - - ( ) -
www.elegantlighting.com
Page 5
C
MODEL A(inch) B(inch) C(inch)
MRE8003 19.5 27.5 5.5
D(inch)
5.1
A
B
D D