
LNK-IMC208P-SFP
Hardened Unmanaged 8-port 100Base-FX SFP + 2-port 10 100 1000Base-T SFP Combo Optical Ethernet
Switch
4 V1.0
Setup
1. Connect one end of the Ethernet cables to their corresponding ports on the product. Connect the
other end to the network equipment such as IP cameras, Switches or PCs. Insert the SFP and
connect the optical fiber cables to its connectors.
2. Connect the product with the power adapter and switch on the product, the PWR indicator should
then be ON. If it is not, please check whether the power cable is connected properly and the power
supply functions normally..
3. After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 5).
Inter ace
RJ-45 Pin Assignment
1000Base-T Pins
Pin MDI MDIX
1 TP0+ TP1+
2 TP0- TP1-
3 TP1+ TP0+
4 TP2+ TP3+
5 TP2- TP3-
6 TP1- TP0-
7 TP3+ TP2+
8 TP3- TP2-
Power Connection:
::
:
Pin
Description
V1 - V1 + V2 - V2 +
Power Input GND
+12~48V
(DC)
GND
+12~48V
(DC)
Cable Connections
Signal Type Cable Type Connector
Ethernet Cat. 5 or above RJ45
Optical SM MM Optical fiber cable (depends on SFP) LC
Power supply 1 Power cable 6-pin Terminal Block
(
Pin 1 2
)
Power supply 2 Power cable 6-pin Terminal Block
(
Pin 5 6
)
ALM UTP 6-pin Terminal Block
(
Pin 3 4
)