Enclume LR35 User manual

Enclume
JOINED HOOP LOG RACK
Model LR35
Quality, design, strength and function –
Features we build in you can count on.
Congratulations for acquiring one of the finest
Hearthside log racks made.
WARNING:
READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK.
:
ASSEMBLY INSTRUCTIONS for LR35
Hardware included:
4 – 5/16"x 5/8"Button head screws
2 – 5/16"x 1/2"Button head screws
1 – 3/16"Allen wrench
Components included:
2 – Hoop body pieces
2 – Legs
2 – Crossbars
1 – Upper Support Bar
ASSEMBLY STEPS
1) Place a hoop body piece on top of and parallel to one of the legs. Place the crossbars perpendicular to
the hoop body piece aligning the holes and insert one of the four 5/16"x 5/8"button head screws
through all 3 holes on both sides (see figure 2). Repeat this step on the other side of the hoop in the
same leg. The screws should be inserted from the top down toward the floor. Tighten the screws only
finger tight while assembling. Repeat for the other hoop and leg.
2) Using the 5/16"x 1/2"button head screws, attach the Upper Support Bar under the top of the hoops
aligning the holes and inserting the screw from the top down.
3) Square up your rack and tighten all the screws firmly.
See reverse side for exploded drawing and warranty information.
Enclosed you will find everything needed for the
assembly and use of your storage rack. Two
people make assembly and installation easier.
The parts and hardware included are:

It is important that your rack is assembled correctly. If the unit is assembled or
used incorrectly, it could become unstable possibly causing injury.
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Your exclusive
remedy is the repair or replacement of the defective product and shall be subject to the following conditions: (1) receipt of your notice of any
defect by Enclume within the warranty period and (2) your return of the defective product to Enclume Design Products, 24 Colwell St. , Port
Hadlock, WA 98339, postage prepaid ,within 20 days following the issue of a return authorization number (“RA”) to you by Enclume (which
RA may be obtained by telephoning the number at the bottom of this instruction. There are no other warranties, expressed or implied. THERE
ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTIC ULAR PURPOSE. ENCLUME SPECIFICALLY
DIS-CLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE PURCHASE OR USE OF
THIS PRODUCT.
WARNING
Fi
g
ure 1
Figure 2