Encore 5.1 Channel Surround Sound Card ENM232-6VIA User manual

Physical Connections:
ENM232-6VIA port assignments:
1. MIC
2. LINE
3. FRONT OUT
4. REAR OUT
5. BASS
CD IN: Analog CD/IN Port (Signals: L-G-G-R)
ENM232-6VIA
5.1 Channel Surround Sound Card
User’s Manual
Ver.1.1

Feature Highlights
zFull-duplex 6CH DAC/2CH ADC
zSupports 96K/24 bit playback; 48K/16 bit recording
zPCI Rev. 2.2 compliant with bus mastering modes
zSupports the latest Dolby® Digital EX and DTS ES
5.1 CH DVD soundtrack playback
zDirectSoundTM 3 HW acceleration
zZoomed Video Port Support
zACPI compliant power down management
System Requirements
zIntel® Celeron 350MHz or AMD® K6II 500MHz or
better
z128MB RAM or better
zCD-ROM Drive
zWindows® 98SE, Me, 2000, XP, Windows Vista™
zDirectX™ 8.1 or above required
Installing driver on Windows® 98SE/ME/2000/XP/
Windows Vista™
1. Locate an available PCI slot on your computer, and
insert the ENM232-6VIA 5.1 Channel Sound Card
into the slot. Fasten the card to the case using a screw;
2. Turn computer power on. Windows® will detect the
Sound Card as “PCI Multimedia Audio Device” or
“MultimediaAudio Controller” device. Click
“Cancel” button. We recommend to use the sound
card setup utility instead of Windows at this time.
3. Place the Setup disc CD into the CD-ROM drive.
Click the Start button on the taskbar and click Run.
Type “D:\autorun.exe”. (assuming D: is your
CDROM drive letter)
4. Follow the on-screen instructions to complete the
utility software installation
5. When installation is finished, restart your computer