Encore ENUTV User manual

Personal Video Recorder
ENUTV
(USB TV box)
User’s Guide
http://www.encore-usa.com

English
Chapter 1: Introduction
1.1 Package Contents
Upon receiving your ENUTV, please make sure the following items are included in the USB TV
Super Mini package.
•ENUTV
•Driver CD
•Quick Guide
•Video & Audio in connecter
1.2 System Requirements
•IBM PC or compatible
•P4 1.6 (for Preview); P4 2.4 or above(Mpeg 4 need 2.8) (for Record )
•Minimum 128 MB memory (256MB is better)
•Minimum 100 MB hard disk space available
•VGA and with DirectDraw driver supporting 16 bit color or higher
•One free USB2.0 / 1.1 slot
•Microsoft Windows 2000 or XP
•CD-ROM drive
Chapter 2: Getting Started
2.1 Connect USB TV Super Mini
To install the ENUTV into your computer, follow the steps below:
1. Connect the antenna cable to the
connector.
2. Connect the Device to PC USB
Hub.
1

English
2.2 Device Driver Installation for Windows XP
1. Once you connect ENUTV to the
USB port, you can just follow the
system’s prompted messages to
finish the driver installation.
2. When you insert ENUTV, system
will show the “Found New
Hardware” dialogue box.
3. Select “No, not this time”
Click “Next” to start installation.
2

English
4. Select “Search for a suitable
driver for my device
[recommended]” and click “Next”.
5. Select “CD-ROM driver” and click
“Next” button to search driver.
6. Click “Continue Anyway”
3

English
7. Click “Next” to continue the
installation.
8. Click “Finish” to complete the
driver install. Check your
driver ”ENUTV” from Device
Manager after installation.
2.3 Install ENUTV utility software.
1. Click “Next” button to start installing.
4

English
2. Please read the License
A
greement
and click “Next” to begin copying
files.
3. Click “Next” or choose setup folder
for installation.
4. Then click “Finish” to complete the
installation of ENUTV.
5

English
5. “Start”, “Shut Down”, “Restart” to
restart your computer.
6

English
Chapter 3: Launch the Software
3.1 Running ENUTV for first time.
Click Start on Windows Taskbar, and then select Programs\ENUTV
1. Click ENUTV icon on the desktop.
2. Then the scanning device will start.
7

English
At the first time running, you should complete the setting and channel scanning.
1. Although the TV tuner on
ENUTV is fixed, you have to set
up the country or region right
after the first time you launch
ENUTV
2. Then press Search to scan the
TV channel.
3. After searching is finished, click
ok to start watching TV.
8

English
3.2 Watch TV or VCR
1. TV wall display: Show 4x4 TV wall on screen
2. Channel List: This is listing all available TV channel.
3. Channel control: Set channel up or down
4. Volume control: Adjust the Volume or mute.
5. Search TV channel: Click to search available TV channel.
6. Double click to full screen display..
7.
6. Double click to full screen
3.Channel Control
2.Channel List
4.Volume Control
1.TV wall display
5.Search TV Channel
3.3 Record Video
Click “Record” button to start recording
video.
You can use the control panel or setting
table to set the video format. It can be
set to the following format.
9