Enegic Monitor User manual

Quick Start Guide
Inst ll tion, Congur tion & Integr tion
with E see ch rging box
In the product p ck ging:
1x Enegic Monitor 3x Current sensors
1x USB or DIN
Adapter
1x E see License
Scan the cod
FAQ, step by step Inst ll tion & Congur tion videos
[email protected]om
v 1.0 enegic.com [phone]

Installation
This is a guide how Enegic monitor is
installed with current sensors in a
commonly used electrical cabinet.
These steps should be performed by a
ualied electrician.
1Open the electrical cabinet & locate the
phase conductors. Usually, L1 is brown,
L2 black and L3 gray.
2
Connect the current sensors so that the
consumption of the entire property is
measured.Tighten the current sensors
around the phase conductors.
3 4 Guide the cables out of the electrical
cabinet.
Open the measuring unit.
5 6 Plug the current sensors into the
terminal block. L1 to 1, L2 to 2 and L3
to 3.
Connect cables with ,
and cables with black pins to -.
red pins to +
7 8 Power the device with the included DIN
or USB cable. Connect cables with
, and cables with black pins to -.
red
pins to +
1
[email protected]om
v 1 . 0
enegic.com
[phone]

Fasten the cables with cable ties
and put back the cover.
9Power the device with the included
DIN or USB adapter. Place the
measuring unit accessible, but in a
weather-protected space e.g. indoors
or in a facade cabinet. Attach the
device with the included Velcro strap.
10
1Check that the device is in
conguration mode:
If not, press the bottom button for
~10 seconds until it starts flashing
blue.
Open the enegic app and log in with
your installer account. Then enter the
customer's account name in the
“Impersonate” eld and log in again.
2
3Go to Settings, New device and
Congure new physical device. Congure the device according to the instructions in the app. Once the
device is congured, it will appear in
“Overview”.
4
Conguration2
[email protected]om
v 1.0 enegic.com [phone]

Frequency r nge: 2412 - 2484 MHz • M ximum TX Power: 20 dB
Hereby, Perific Technologies AB decl res th t the r dio equipment type, Enegic Monitor, is in compli nce with Directive 2014/53/EU. The full
text of the EU decl r tion of conformity is v il ble t the following internet ddress: www.enegic.com/ce.
Use the Easee Installer app to change the operator of the charging box to "Skårebo -
Powered by Enegic". It is also possible to make the operator selection logged in to the
user's account in easee.cloud.
To do in Easee Cloud
In the enegic app, go to Settings,
Licenses to scan the QR-code on
the included Easee license.
1Go to Settings, New Device and
Add new virtual device and
follow the instructions in the app.
2
When you successfully added the
virtual device, go to Settings,
Reporters and Add new
Reporter.
3 4 Select Easee Control as the type of
reporter and enter an appropriate name
such as “Easee power control”.
Enter the serial num b er of the
Easee charger, main fuse si z e,
charger fuse si z e and a safe
charge level if the device goes
offline.
5
Ensure the correct Enegic monitor
is selected. T hen press Save.
6
Integrate the device with Easee3
[email protected]om
v 1.0
enegic.com
[phone]