Enuresis Solutions DryBuddy 2 User manual

•Makingasaltwatersolutionusingalittlecommonsaltand
placingitinacuporbowl.Dipbothoftheatmagnetic
padsinthesolution,or
•Placingacleanmetalconductor(suchasakey,
screwdriverorknife)acrossthetwomagneticpadsand
makinggoodelectricalcontact.
ThisactivatestheSensor.TheReceiver’slightwillashGreen
andthenturnOFFindicatingasuccessfulSync.
Notes: If the new synchronization is not completed within 15
seconds, the Blue light will stop and the Receiver will revert
to its synchronization before the new synchronization was
attempted, and switch itself OFF. Once the Sensor has been
activated it cannot be activated again for two (2) minutes.
DonotsynchronizetheDryBuddy2whiletheReceiveris
indicatingalowbattery(Yellowblinkinglight).Insertfresh
batteriesandsynchronize.TheSyncbuttonwillnotfunction
whenthepowerisON.You must re-synchronize theSensor
andReceiverifeithertheSensorortheReceiverischanged
orsynchronizationislostforanyreason.
To Use Multiple DryBuddy2 ReceiversallReceiversmust
besynchronizedatthesametimewiththeSensor.Withthe
Receivers’powerOFF,presstheSyncbuttononthesideofevery
Receiver.WhilealloftheReceiversareashingBlue,triggerthe
Sensor.TheprocessissimilartosynchronizingasingleReceiver,
butallReceiversaresynchronizedsimultaneously.
DryBuddy2 Instructions & Details (Con’t)
3
4 5 6
1 2
TheDryBuddy2oersconvenience,privacyandreliabilityto
patients(orchildren)whoneedtobealertedwhenenuresis,
bed-wettingorunintentionalurinationoccurs.Itistruly
wireless,andcanbeusedwhentheDryBuddy2 Receiveris
beingcarriedbythepatientoriswithinproximity(upto22
metersor72feet)ofthewirelessSensorbeingusedbythe
patient.
DryBuddy2 Controls
AllcontrolsoftheDryBuddy2areonthecircularsideofthe
DryBuddy2Receiver.ExceptfortheOn/Oswitches,these
switchesarebelowthesurfaceandcanbereachedand
pressedbyusingadullpointedinstrumentsuchasasmall
screwdriverorstraightenedmetalpaperclip.Thisprevents
anyaccidentalorunintentionalswitchingoftheDryBuddy2.
Toavoiddamagingtheselittleswitches,pleaseusecare
anddonotpresstheseswitcheswithforce.
Switching the DryBuddy2 ON and OFF
WhenthetwoPowerON/OFFbuttonsarepressedtogether
fortwo(2)seconds,thepowerwillbeturnedONorOFF.
WhenthepoweristurnedON,aGreenlightwillashtwice.
WhenthepoweristurnedOFF,aRedlightwillashtwice.
When the Receiver power is OFF,pressingthesmallcontrol
buttons(switches)onthesideturnstheReceiveronbriey
sothatthebuttonscanfunctionandtheReceiverissetto
thenextnewsettingforthebuttonbeingpressed.
When the Receiver power is ON,pressingthesmallMode
buttonactivatestheReceiverandindicatesthecurrent
settingoftheReceiver.(Mode,SoundandVolume).TheVol.
andSoundbuttonswillnotfunctionwhenthePowerisON.
Sync
TheDryBuddy2SensorandReceivermustbesynchronized
sothattheyworkwiththesamecode.AnewDryBuddy2
systemhasbeensynchronizedatthefactory.Tore-
synchronize,rstmakecertainthatthePowerisOFF.Then:
1.PresstheSyncbuttonintheside.ABluelightwillash,
andtheReceiverisplacedinsynchronizationmodefor
fteen(15)seconds.
2.WhiletheBluelightisashing,shortthetwomagnetson
theSensorby:
Mode
TheModeswitchallowstheusertochangethemodeor
typeofalert.
When the power is ON: PressingtheModebuttonplaysthe
currentsettingsfortheReceiver.
When the power is OFF: Each“press”oftheswitchwill
resultinthealertchanginginthefollowingorder:
1.Soundonly
2.Sound+StrongVibration
3.StrongVibrationonly
4.LowVibrationonly
EachtimethattheModeswitchispressed,thealertonly
changesinthedirection
1.→2.→3.→4.→ 1.
Volume
TheVol+and-buttonsincreaseordecreasethevolumelevel
ofthesound.TheDryBuddy2hasve(5)volumelevels.The
modemustbesettoMusicsothatthesoundcanbeheard.
When the power is OFF:Pressingthe+or-buttonchanges
thesoundsettingtothehigherorlowervolumesettingand
thisnewvolumeisheardbriey.Ifthesoundvolumeistobe
increasedordecreasedfurther,pressthe+or-buttonsagain.
Note: The volume buttons set the sound volume to what
will be heard if the DryBuddy2 is set to the Sound or
Sound+Vibration modes.
Note: The Volume buttons will not function when the power
is ON.
Sound
TheDryBuddy2oerstwoaudiblealarms–aTrumpet
FanfareandaBerlinPoliceSiren.Thesoundcanbe
changedbypressingtheSoundbutton.Themodemustbe
settoMusicsothatthesoundcanbeheard.
When the power is OFF:PressingtheSoundbutton
changesthesoundtothenextsound-eithertheTrumpet
FanfareortheBerlinPoliceSiren.
Note: The Sound button will not function when the power is ON.
Length of Alert
Ifthealarm’salertisnotturnedOFFmanually,thealarmcan
continueforaShort Alert timeoraLong Alerttime.
WithaShort Alert,thealertwillstopafterabout2minutes,and
theReceiverwillbeswitchedOFF.Thisisthedefault(factory)
settingfortheDryBuddy2.
WithaLong Alert,thealertwillkeeprepeatingitsalertcycle
tilltheReceiverismanuallyswitchedOFForthebatteriesare
drained.
Tosetthelengthofthealert,rstpresstheSyncbutton.
WhiletheBluesynclightisashingfor15seconds:
1.ForaShort Alert,presstheVol.–button.Ayellowlight
willashonce.
2.ForaLong Alert,presstheVol.+button.Ayellowlight
willashtwice.
TheReceiverautomaticallyturnsitselfOFFaftertheYellow
lightashes.TheReceivermustnowbeswitchedONagainin
ordertocontinueusingtheDryBuddy2.
When to Synchronize
EveryDryBuddy2Sensorhasitsownuniquecodetransmitted
totheReceiver.ThisallowsmanyDryBuddy2systemstobein
closeproximitywithoutinterferingwithoneanother.IftheSensor
orReceiverischangedorsynchronizationlostforanyreason,the
SensorandReceivermustbesynchronizedagain.
DonotsynchronizetheDryBuddy2 whiletheReceiveris
indicatingalowbattery(Yellowblinkinglight).Insertfresh
batteriesandsynchronize.
DryBuddy2 Instructions & Details DryBuddy2 Instructions & Details (Con’t)
DryBuddy2 Instructions & Details (Con’t) DryBuddy2 Instructions & Details (Con’t)
DryBuddy2 Instructions & Details (Con’t)
B3
B4 B5 B6
B1 B2

Receiver
•Usestwo(2)replaceableAAAalkalinebatteries.
•Usesauniquecodingsystemsothatitcanonlybeused
withaDryBuddy2Sensor.
•MustbesynchronizedwithaDryBuddy2Sensor.
•Typicalreceptiondistanceisuptotwenty-two(22)
metersorseventy-two(72)feetfromtheSensor.Theactual
transmissionrangedependsonthematerialsthroughwhich
thewirelesssignalmustpass,thematerialsthatsurround
theSensorandReceiver,,theirpositioning,electricalnoise,
andotherconditionsthatcanaectthesignal.
Sensor
•Canbeattachedtostandardcottonbriefsusingthe
patentedmagneticattachmentsystem,or
•CanbeattachedtooptionalDryBuddywetnesssensing
briefswhichcontainpatentedredundantwiring.Thesebriefs
provideareliableandverylargewetnesssensingarea.
•Usesauniquecodingsystemsothatitcanonlybeusedwitha
DryBuddy2Receiver.
•MustbesynchronizedwithaDryBuddy2Receiver.Inanew
DryBuddy2system,theSensorandReceiveraresynchronized
andcanbeusedwithoutfurthersynchronizations.
•Typicaltransmissiondistanceisuptotwenty-two(22)meters
orseventy-two(72)feettotheReceiver.Theactualtransmission
distancedependsuponobjectsandmaterialsbetweenand
surroundingtheSensorandReceiver.
•Sealedunitwithnon-replaceablebattery.
•Designedandtestedtotrigger(transmit)over800times
undertypicalandproperuse.
•Whentriggered,theSensorwillremaininactivefor2
minutesbeforeitcanbetriggeredagain.
•CerticationsandRegistrations:
 FCC  CE
 FDA  RoHSCompliant
Note: Once a Sensor is triggered (or shorted) to transmit an alert signal,
the Sensor will remain inactive for two (2) minutes and cannot be
triggered again till this inactive period is over.
Sensor
Weight(withoutbatteries):40gr
65mm 23.5mm
Weight:26gr
TheDryBuddy2isdesignedinUSA.AssembledinChina.
©2018byEnuresisSolutions,LLC
Enuresis Solutions, LLC
51W.FairmontAvenue,Suite2
Savannah,GA31406USA
912-352-8854
[e-mail]
Thegranteeisnotresponsibleforanychangesormodicationsnotexpressly
approvedbythepartyresponsibleforcompliance.Suchmodicationscouldvoidthe
user’sauthoritytooperatetheequipment.
ThisequipmenthasbeentestedtocomplywiththelimitsforaClassBdigitaldevice,
pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonable
portectionagainstharmfulinterferenceinaresidentialinstallation.
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothe
followingtwoconditions:(1)Thisdevicemaynotcauseharmfulinterference,and(2)
thisdevicemustacceptanyinterferencereceived,includinginterferencethatmay
causeundesiredoperation.
•TheDryBuddyalarmisintendedforuseasabed-wetting
andenuresisalarmbychildrenofageveandolder,oras
recommendedbyamedicalauthority.Itcanbeusedbyolder
patientsasaurineSensorandwetnessalarmandasan
incontinencealarm.
•TheDryBuddysystemisamedicaldeviceandshouldbe
treatedassuch.Donotuseroughlyordamage.
•Donotuseasapottytrainingaidforbabies,toddlersand
veryyoungchildren.
•MakecertainthatnopartsoftheDryBuddyorSensorare
putinthemouthforanyreasonasthiscouldcausechokingor
otherharm.
•ObserveallsanitaryprecautionstokeeptheSensorcleanand
thealarmpartscleananddry.
•DonotusetheSensorformorethanoneuserwithout
thoroughcleaning.
•DonotstrikethemagneticSensororcaponhardsurfacesor
makethemhotasthiscanreducemagnetism.
•TheDryBuddysystemisdesignedtosenseurineorsalty
water.Itislesseectiveinsensingplainwater.
DryBuddy2 Specications (Con’t)
9
Good Things Happen with DryBuddy�
Raising the Standards for Mobility,
Privacy, Performance and Value.
FCC Warning:
10 11
7 8
DryBuddy2 Specications DryBuddy2 Specications (Con’t)
Caution when Using the DryBuddy2 System
DryBuddy2 Specications (Con’t)
•Containsanaudioalarmwhichcanbeasloudas93dBat
20cms.(8”),89dBat40cms.(16”),86dBat60cms.(24”).
PleaseadjusttoasuitableloudnesslevelusingtheVolume
controlintheReceiver.
•CerticationsandRegistrations:
 FCC  CE
 FDA  RoHSCompliant
32 mm
48 mm
42 mm
17 mm 6 mm
13.5 mm
B9
B10 B11
B7 B8
Weight:11gr