Epcom EPB64FW User manual

Installaon manual for wall mounng for flat screen. EPB64FW
Note: t is recommended that this product be installed only by a professional. We do not accept
responsibility for damages caused by improper installaon, assembly or use of this equipment.
In case of any doubt, please contact a professional to help you.
IMPORTANT.
•For safety reasons, the wall or mounng surface must be able to support the
combined weight of the mounng and the screen; otherwise the structure must
be reinforced.
•Appropriate safety equipment and tool must be used. Failure to do so may result in
property damage or serious injury.
•Make sure electrical wires, water pipes or gas pipes are not located between the wall.
Tools required for installaon
•Screwdriver cross head.
•Electric or portable drill.
•1/8”(3 mm) Drill Bit + Post Detector (installaon in plaster wall)
•7/16”(11mm) Concrete drill bit (concrete installaon)
Make sure all installaon accessories are included with the assembly. Included:
Wall Installaon
(A) M6x50 Delay Bolt
(E) M6x30 Bolt(D) M6x12 Bolt
(G) M8x12 Bolt
(C) Washer
(F) Long spacer
(H) M8x30 Bolt
(B) Concrete anchor
(I) M6 washer
Plaster Wall Concrete Wall
Pole
Pole detector Measuring tape Measuring tape
Use a pencil to mark the holes
Use a pencil to mark the holes
Insert a concrete anchor in each hole
Place the mounng rail on the wall,
fixing it with bolts (A) and washer (C).
Place the mounng rail on the wall,
fixing it with bolts (A) and washer (C).
Select the appropriate bolts for the
installaon, in case of using a long bolt,
the spacer will also be necessary.
Do not use the M6 washer, if using the M8
bolt

Place the display connecon cables at the
back of the rail, then mount the screen in
place. Use the cross screwdriver to adjust the bolt,
you can adjust the angle of the screen by 10�
down to loosen the knob.