Tools included
5mm hex key
1. Position and securely fasten the ceiling
plate to the ceiling.
4. Secure the adjustable arm plate to the
projector by positioning the plate’s screws
with the designated holes on the bottom of
the projector.
2. Insert the calibration device into the
ceiling plate.
3. Position the projector adaptor plate with
adjustable arms on the bottom side of the
projector.
Safety precautions
Failure to comply with these safety precautions could result in death or
serious injury.
At least two qualied people should
perform the installation. Personal injury
and/or property damage can result from
dropping or mishandling the projector.
If mounting to ceiling studs, make sure
that the mounting screws are anchored
into the centre of the ceiling studs.
Use of an edge-to-edge stud nder is
recommended.
Be aware of the mounting environment.
If drilling and/or cutting into the mounting
surface, always make sure that there are
no electrical wires in the wall.
Do not install near sources of high heat.
Do not install on a structure that is prone
to vibration, movement or has a chance
of impact.
Electrical shock hazard
Always turn off, disconnect, and
disengage all power sources to the
projector before servicing.
Maximum projector weight limit is 45kg
(99 lbs).
Installation manual
ELPMB68 Ceiling Mount
V12H006AE0
