Erden O-Clean User manual

Power port
Micro USB for
temparature notification
Air inlet
silicone tube port
Mini USB for ozone
machine notification
Color: White
Power supply voltage: DC12V
Power consumpion: 4.5W(max)
Size: 100(L)x100(W)x32(H)mm
Weight: 300g±10%
Ozone output: 150mg/hr
*Ozone Machine Fittings*
O-Clean Installation
O-Clean (Ozone Machine)
Ozone spillover density in an open area is under 0.01 ppm, certified by SGS test.
A.O-Clean C.AC Adapter D.Silicone tube
E.Cable Tie
F.Screw and Plastic
Screw Holder G.Velcro
B.Microbubbles/
Ozone Mixer
H.Adapter

Standby : Red Light
O3 : Blue Light
On/Off
Power Button
Power Indicator
A. O-Clean
A. O-Clean
1.
A. O-Clean
Ozone Machine
A. O-Clean
Ozone Machine
2.
3.
5. 6.
4.
B.Microbubbles/
Ozone mixer
E. Cable Tie
D.Silicone tube
I.
II.
C.AC adapter
I.
II.
male
female
STEP1
Hang the ozone machine on the wall, or
use Velcro to connect both wall and the
backside of machine.
CAUTION: The machine Should hang 6” above
the tap. Velcro can only be put on tile or a smooth
surface.
STEP4
Connect one side of silicone tube to the
ozone silicone tube port and another side of
silicone tube please connect to microbub-
bles/ozone mixer. And than use the cable ties
to secure the silicone tube.
STEP5
Plug the AC adapter into the ozone
machine and the power outlet.
STEP6
Press the power button on side of the ma-
chine. If the blue light indicator is on firmly,
then installation is complete.
I. Take the original aerator off the faucet.
II. If the faucet is male, please attach the
ozone microbubbles / ozone mixer direct-
ly to the faucet and insert silicone tube.
I. Take the original aerator off the faucet.
II. If the faucet is female, please connect
the included adapter and then attach the
microbubbles/ozone mixer to the faucet.
Once completed, the silicone tube can be
connected.
STEP2
STEP3
B.Microbubbles/
Ozone mixer
* The port is located on the bottom side.
H.Adapter