Ergomotion RF377B User manual

Issue Department：Bedding Division Date：2017-8-15
System Instruction Author：
Instruction of RF377B Edition：1.1
Page 1 of 2
1/3
Instruction of RF377B
1. Electricalconfigurationdiagram：
Head up
Head down
FLAT
Foot up Foot down
Zero-G
RF377B RF377A

Issue Department：Bedding Division Date：2017-8-15
System Instruction Author：
Instruction of RF377B Edition：1.1
Page 2 of 2
2/3
2.Item
2.1 Head up
Press and hold HEAD UP button of remote, head actuator moves out, stop when
released；
2.2 Head down
Press and hold HEAD DOWN button of remote, head actuator moves in, stop when released；
2.3 Foot up
Pressa and hold FOOT UP button of remote, foot actuator moves out, stop when released;
2.4 Foot down
Press and hold FOOT DOWN button of remote, foot actuator moves in , stop when released；
When moving to flat position, lumbar actuator and tilt actuator move first, after 500ms, head
andfoot actuators start moving;
2.5 Flat
Click FLAT button, the bed goes flat, stop when click any button during the process of going
flat；
2.6ZeroG
Releaseafterpress,2liftsmovetoZero‐Gposition

Issue Department：Bedding Division Date：2017-8-15
System Instruction Author：
Instruction of RF377B Edition：1.1
Page 2 of 2
FCC：
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment.The device has been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un
autre environnement.ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux
rf.
3/3

FCC ID: 2AK23RF377AB
IC: 22406-RF377AB
FCC ID: 2AK23MC122
IC:22406-MC122
control box
Foot Motor
Head Motor
Massage motor
Power Supply
Power cord AC