ERGOPIXEL GD-0003 User manual

70KG
25mm/s
100-240V
710mm
1210mm
1000-1600mm
0~40°C
2
500-800mm
Ax1
5x 5 2.5 x2 .5 4x 4
Bx4
M4
CX4
M6
DX14
ST4.2
EX8
M6
x4
F
M8
x1
G
Assembly Video:
MODEL : GD-0003

1 2 3
4 5 6
211
1 1 2
Left Column Right ColumnPedestal
Transmission rod Side BracketSupporting beam
BafflePower cable Control Box
HandsetCable tie Handle Screw
7 8 9
21 1
10 411 112 2
2
1
3
4
5
6
7
9
10
8
12
11

Install (1), (2) & (3) together, using the 5 x 5 allen key (A)
to tighten the screws (E).
Unscrew the 4 screws on supporting beam (4) with
the 4x4 allen key (A).
Pull out the supporting beam (4).

Install supporting beam (4) on the columns (2)(3).
Tighten the screws (F) with the 5x5 allen key (A).
Loose the screws on transmission rod (5) and insert to
column (2).
Rotate and insert the transmission rod to (3) and use
2.5 x 2.5 allen key (A) to tighten it.

Connect side bracket (6) with column (3). Use the 5x5
allen key (A) to tighten the screws (C).
Connect side bracket (6) with column (2). Use the 5x5
allen key (A) to tighten the screws (C).
Attach the desktop with screws (D), the distance between
supporting beam (4).
Both sides shall not be greater than 200mm.

Install the control box (8) with screws (D) as shown in
the image below.
Install the handset (11) with handle screws (12) as
shown in the image below.
Tighten all screws on transmission rod (5) and attach
the desktop with screws (D), the distance between
supporting beam (4).

Install the baffle (7) on both side of the supporting
beam (4) with the screws (B), and then use 2.5*2.5
allen key (A) to tighten.
9
11
8
AC
H S M1 D C
Power Port
Port for cable
connected to
the lifting column
Port for
handset
Assembly Video: