ESCALADE Minnesota Fats MFT800-TBL User manual

1-866-556-2757
FAX: [phone]
We strive to ensure that our products are of the highest quality
and free of manufacturing defects or missing parts. However, if
you have any problems with your new product,
DO NOT RETURN IT TO THE STORE,
please contact us toll free @:
Or write to:
Escalade Sports
Customer Service Department
P.O. Box 889
Evansville IN 47706
Your Model Number ____________________
have your model number when inquiring about parts.
[email protected]
Please
Date Code ___________________________
2-MFT800-TBL- -FS
© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
When contacting Escalade Sports please provide your model number, date
code (if applicable) and part number if requesting a replacement part. These
numbers are located on the product, packaging, and this owners manual.
1
All Rights Reserved.
Purchase Date ________________________
PLEASE RETAIN THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
MFT800-TBL

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
2
All Rights Reserved.
IMPORTANT! READ EACH STEP
IN THIS MANUAL BEFORE YOU
BEGIN THE ASSSEMBLY.
Allen Wrench T1 Included with the Hardware Kit
Furniture Polish and Cloth
Make sure you understand the following tips before you begin to assemble your pool table.
1. Start all bolts by hand before tightening.
2. Some drawings or images in this manual may not look exactly like your product. Please
read and understand the text before starting each assembly step.
An electric screwdriver is helpful in assembly. However, please set at low torque and use
extreme caution with an electric screwdriver because you could overtighten the hardware
and strip the screws.
TWO ADULTS ARE REQUIRED TO ASSEMBLE THIS
THIS MINNESOTA FATS 7.5FT COVINGTON POOL TABLE
Assembly Tips
Tools Required:
READ AND FOLLOW ALL ASSEMBLY, OPERATION, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO
ADULTS ARE NEEDED TO PUT THIS POOL TABLE
TOGETHER.
ATTENTION:

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
3
All Rights Reserved.
HARDWARE IDENTIFIER
H1 - 5/16” x 1-1/2”
Allen Head Bolt (12)
H2 - 5/16” x 3/4”
Flat Washer (28)
H4 - 4mm x 10mm
Phillips Round
Head Screw (16)
(To Scale)
T1 - Allen Wrench (1)
(Not to Scale)
H3 - 5/16” x 1/2”
Lock Washer (28)
H6 - 5/16” x 1-3/8”
Allen Head Bolt (16)
H5 - 4mm x 12mm
Phillips Round
Head Screw (36)

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
4
All Rights Reserved.
(Not To Scale)
PARTS IDENTIFIER
P1 - Pool Table Cabinet (1) P2- Side Apron with
Hinges installed (2)
(Packed under the table)
P4 - Corner
Post (4)
P5 - Leg
with Leg Levelers
installed (4)
P3 - End Apron with
Hinges installed (2)
(Packed under the table)
P6 - Leg
Support
Brace (4)
(Not To Scale)
ACCESSORIES IDENTIFIER
A1 - Cue Stick (2) A2 - Triangle (1)
A5 - Billiard Ball Set (1)
A3 - Playfield
Cloth Brush (1)
A4 - Cue Chalk (2)
!
WARNING:
CHOKING HAZARD
Small parts.
Not for children under 3 yrs.
C2 - Leg
Leveler (4)
C1 - Hinge (12)
PRE-INSTALLED PARTS

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
5
All Rights Reserved.
STEP 1:
Find a clean, level place to begin the assembly of your pool table. We recommend building the table on the box
top to protect the parts during assembly. It is very important to assembly table on a level and flat surface.
With the help of another adult, install
Note : The P2 & P3 side and end aprons are packed under this table. With a minimum of two adults , carefully lift one
long side of the table and the 3rd adult can reach in and remove these apron cartons. In order to best protect this table,
the 2 cartons are taped into place .
P2 Side Aprons and P3 End Aprons with P4 Corner Posts attach as shown
in FIGURE 1.
IMPORTANT NOTE: SLIDE P4 CORNER POSTS WITH ARROW POINTING DOWN.
PARTS REQUIRED:
2 pcs - P2 Side Apron 4 pcs - P4 Corner Post
2 pcs - P3 End Apron
P2
P3
FIGURE 1
P2
P3
P4
NOTE: Slide P4 Corner
Posts with arrow
pointing down.
STEP 2:
Install P5 Legs to each P6 Leg Support Brace using H1 Allen Head Bolts,
H2 Flat Washers and and H3 Lock Washers as shown in FIGURE 2.
Use T1 Allen Wrench to tighten all H1 Bolts.
PARTS REQUIRED:
12 pcs - H1 Allen Head Bolt
12 pcs - H2 Flat Washer
12 pcs - H3 Lock Washer
4 pcs - P5 Leg
4 pcs - P6 Leg Support Brace
1 pc - T1 Allen Wrench
FIGURE 2
P6
P5
H2
H3
H1
C2
Leg Leveler

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
6
All Rights Reserved.
PARTS REQUIRED:
16 pcs - H2 Flat Washer
16 pcs - H3 Lock Washer
16 pcs - H4 Phillips Round Head Screw
16 pcs - H6 Allen Head Bolt
1 pc - T1 Allen Wrench
FIGURE 3
H4
H4
P4
STEP 3:
Install P5/P6 Leg Assemblies onto Aprons using H6 Allen Head Bolts with H2 Flat Washers and H3 Lock Washers
as shown in FIGURE 3. Use T1 Allen Wrench to tighten all H1 Allen Head Bolts.
Next, secure P4 Corner Posts using H4 Phillips Round Head Screws as shown in FIGURE 3.
IMPORTANT NOTE: TIGHTEN, BUT DO NOT STRIP OUT H4 SCREWS.
H6
H3
H2
P5/P6
Leg Assemblies

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
7
All Rights Reserved.
STEP 4:
Install Lower Cabinet with Leg Assembled to P1 Pool Table Cabinet as shown in FIGURE 4.
Once all 4 sides are laying correctly onto the pool table understructure , attach this assembly using H5 Screws
onto the C1 hinges as per Detail A.
IMPORTANT NOTE: TIGHTEN, BUT DO NOT STRIP OUT H5 SCREWS.
Note : Once the aprons with legs
assembly is placed onto the pool
table understructure , fold down
all connecting hinges and center
this assembly onto the pool table
understructure all four sides .
PARTS REQUIRED:
36 pcs - H5 Phillips Round Head Screw
FIGURE 4
THIS STEP REQUIRES FOUR OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL. THE TABLE IS VERY HEAVY.
DO NOT REST TABLE ON THE TWO SIDE LEGS WHILE
TURNING THE TABLE UPRIGHT AS THIS COULD DAMAGE
THE LEGS.
ATTENTION:
DETAIL A
C1
H5
H5
C1

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
8
All Rights Reserved.
INSTRUCTIONS FOR LEVELING A POOL TABLE
Assemble pool table according to the instruction.
Any type of level would be sufficient to perform this procedure. However, a two-foot level is
recommended.
Before leveling, make sure level is placed on the playing surface, not the rails.
Level the ends between the corner pockets: Place the level on the playing surface between
the two corner pockets and adjust the height using leg levelers attached underneath the leg
apposite of which the bubble in the level favors until the bubbles rests in the middle of the
level.
Repeat the step above to the opposite corner pockets.
Next, level the length of the table. Place the level next to the side pocket and adjust the
height to position the bubble in the middle of the level, using the leg leveler beneath the leg
opposite of which the bubble in the level favors.
Repeat the step above to the opposite length of the table.
Recheck both short ends to ensure bubble is in the middle on the level.
Depending on the surface the pool table sits, especially deep pile carpenting, the pool table
needs to settle for 24 hours. Recheck the level on each side of the table after 24 hours.
UN-LEVEL UN-LEVEL LEVEL
Leg
Leveler
Leg
Leveler

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
9
All Rights Reserved.
CARE AND USE OF YOUR TABLE
1. Use spray furniture polish to clean all exterior surfaces of your pool table.
2. Use the table brush provided to clean the cloth on the table.
3. This product is intended for INDOOR use only.
4. DO NOT sit, climb or lean on the table.
5. DO NOT drag the table when moving it. This will damage the legs.
Congratulations! You have now assembled your pool table. Please note the Care
and Use instructions below to insure many years of trouble free use of your pool
table.
MFT800-TBL PRODUCT PARTS LISTS
6. DO NOT set drinks on the table.
MFT800-TBLFSH1 H1 5/16” x 1-1/2” Allen Head Bolt 12
MFT800-TBLFSH2 H2 5/16” x 3/4“ Flat Washer 28
MFT800-TBLFSH3 H3 5/16” x 1/2“ Lock Washer 28
MFT800-TBLFSH4 H4 4 mm x 10 mm Phillips Round Head Screw 16
MFT800-TBLFSH5 H5 4 mm x 12 mm Phillips Round Head Screw 36
MFT800-TBLFSH6 H6 5/16” x 1-3/8” Allen Head Bolt 16
MFT800-TBLFST1 T1 Allen Wrench 1
MFT800-TBLFSP1 P1 Pool Table Cabinet 1
MFT800-TBLFSP2 P2 Side Apron 2
MFT800-TBLFSP3 P3 End Apron 2
MFT800-TBLFSP4 P4 Corner Post 4
MFT800-TBLFSP5 P5 Leg 4
MFT800-TBLFSP6 P6 Leg Support Brace 4
MFT800-TBLFSA1 A1 Cue Stick 2
MFT800-TBLFSA2 A2 Triangle 1
MFT800-TBLFSA3 A3 Playfield Cloth Brush 1
MFT800-TBLFSA4 A4 Cue Chalk 2
MFT800-TBLFSA5 A5 Billiard Ball Set 1
MFT800-TBLFSC1 C1 Hinge (Pre-installed) 12
MFT800-TBLFSC2 C2 Leg Leveler (Pre-installed) 4
MFT800-TBLFSK1 K1 Hardware Kit 1
MFT800-TBLFSM1 M1 Owner’s Manual 1
Part# Key# Description Qty
7. The purchase of a pool table cover will both protect and help keep clean the
entire top of the pool table.

© 2017 Escalade Sports For Customer Service Call 1-866-556-2757
10
All Rights Reserved.
This customer warranty extends to the original owner, on the purchase of any ESCALADE SPORTS
Product (hereinafter referred as the "Product").
This Product is warranted to the original owner, for a period of 90 days from the
original purchase.
ESCALADE SPORTS warrants to the original owner, this product to be free
from defects in material and workmanship when used for the intended purpose under normal use and
conditions. THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN DAMAGED BY ACCIDENT,
UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE, FAILURE TO FOLLOW INSTRUCTIONS
PROVIDED WITH THE PRODUCT OR OTHER CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL
AND WORKMANSHIP.
During the above 90 day warranty period, ESCALADE SPORTS shall
provide replacement components or replace with a comparable product at our choosing. If product is
defective under normal use and proper care, please contact our Customer Service Dept.
Other than shipping requirements no charge will be made for such replacement of in-warranty Products.
Some states do not allow the exclusion or limitation of implied warranties or consequential or incidental
damages, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which
may vary from state to state.
WARRANTY DURATION:
WARRANTY COVERAGE:
WARRANTY REPLACEMENT:
LEGAL REMEDIES:
1-866-556-2757 / Customer Service Dept.
Or Write us at:
Escalade® Sports, Inc. - P.O. Box 889, Evansville, IN 47706
Attn: Customer Service Dept.
Or E-mail us at:
[email protected]
ANY IMPLIED WARRANTIES ARISING OUT OF THIS SALE,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE
ABOVE 90 DAY PERIOD. ESCALADE SPORTS SHALL NOT BE LIABLE FOR LOSS OF
USE OF THE PRODUCT OR OTHER CONSEQUENTIAL OR INCIDENTAL COSTS,
EXPENSES OR DAMAGES INCURRED BY THE CONSUMER OF ANY OTHER USE.
WARRANTY DISCLAIMERS:
90 DAY LIMITED WARRANTY