
ReplacementPartsList
Item # Part # Description Qty.
1 4A-6536-02 Half Top 2
2 2S-6384-00 SideRail (48"Long) 4
3 2S-6385-00 EndRail (53"Long) 2
4 2S-6429-02 Stiffener Rail 2
5 BZ-412 SpongeRubberStrip 12
6 1B-6482-00 #8X 13/32Phillips HexHd 48
7 2L-6713-02 This Owner's Manual 1
8 3M-6494-00 CornerCap 4
9 701-105 #8X 9/16Phillips HexHd 12
1. Determine the placement of sponge rubber strips #5 on the bottom of
half tops as follows (Use Figure 1):
BOTTOM SIDE OF HALF TOPS #1 SHOWN TOP SIDE OF HALF TOPS #1 SHOWN
WITH POOL TABLE UNDERNEATH.
Figure 1
INSTALLATION Figure 2
Ifincorrectlyplaced,markthecorrectpositiononbottomoftheconversion
top, remove top from pool table, and apply strips. Repeat on other half.
Set both half tops on pool table.
3. Install net brackets and net (not furnished with this table).
MAINTENANCE
Wedonotrecommendtheuseofwaxonthistop.Waxtendstomakethe
top excessively shiny.
Toclean,usea warm,damp cloth andWIPEGENTLY! DONOTWIPE
EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE
AMOUNTS OF WATER!
NOTE:Changingweatherconditionsmaycauseaslightwarpageinthe
playingsurfaceofthetable.Thiswillnotaffectplayingconditions.Playing
surface will return to its original condition as the weather stabilizes.
STORAGE
This table MUST be stored indoors.
2L-6713-02
Mark center line (A) along the length of conversion top. Top is 60
inches wide. Center line (A) is 30 inches in from either side.
Measure the width of your pool table.
Divide the width of your pool table in half and mark the bottom of the
conversiontopthisamount(B).Measurefromcenterline(A)outtoward
both sides. These mark the sides of your pool table.
Measure the length of your pool table.
Dividelengthofpooltableinhalfandmarkthebottomoftheconversion
topthisamount(D).Measurefromcenterline(C)(wheretwohalftops
touch)outtowardsbothends.Thesemarktheendsofyourpooltable.
Temporarily tape sponge rubber strips #5 to bottom surface of
conversiontopusingmaskingtape(notincluded).Spacethemevenly
apartasshownabove. (Donotpeelbackingoffstripsyet. Firstcheck
for correct placement. See next step.)
2. Set one half top on your pool table to check for correct placement of
sponge rubber strips #5.
Ifcorrectlyplaced,removetopfrompooltable,peelbackingfromsponge
rubber strips #5 and apply firmly to back of conversion top. Repeat on
other half top. Place both half tops on pool table. LIMITED 90 DAY WARRANTY
Manufacturer warrants to the original retail purchaser, this product to be free from
defects in material and workmanship for a period of ninety (90) days from the date
of purchase.
Should this product become defective due to material or workmanship within the
warrantyperiod, contactour CustomerService Departmentfor repairor replacement
at our option.
This warranty is not transferable and does not cover normal wear and tear, bowing
of the table or damage caused by improper handling, installation or use of this
product. This warranty is also void if product is in any way abused, damaged, or
modified from its original state, or if used for other than residential use.
This warranty gives you specific legal rights, and you may have other rights which
vary from state to state.