Escape MARS SCREEN User manual

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
IMPORTANT INFORMATION.
YOUR SCREEN NEEDS TO ACCLIMATIZE TO YOUR ENVIRONMENT, SO ONCE YOU UNPACK IT, DON’T
SWITCH IT ON FOR AT LEAST 2 HOURS.
EXERCISE VIDEOS AND
WORKOUTS FOR ANY LEVEL.
TOUCH THE
SCREEN TO
GET STARTED.

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
1.
STEP. 1
CONNECT THE POWER CABLE.
When unpacked you will see that the power socket is protected by a safety cover at the
rear of the screen at the bottom (Figure 1). This cover ensures that the power is less likely
to be accidentally disconnected and that the power cable is secure. To attach the power
cable, rst remove the two screws holding the safety cover in place (Figure 1). Once
removed, insert the power cable into socket shown below (Figures 2 and 3). After the
power cable is in place, re-t the safety cover (Figure 4).
Before you plug into a power source, ensure that the power cable is not pulled or put
under strain. The screen can then be connected to the power source.
2.
STEP. 2
POWER UP.
Turn on the screen using the on/o power rocker
switch on the left hand side of the unit as shown
below. The rocker switch has a “I” and a “0”. When
“I” is pressed down, the power is on and the unit
will start when plugged in and power is present.
Figure 1. Figure 2. Figure 3. Figure 4.

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
3.
STEP. 3
CONNECT TO THE INTERNET.
For connection using a wired ethernet connection, insert one end of the
ethernet cable into the port indicated in red below and the other end into
the wall socket or internet router.
The network should provide an ip address and should provide access to
the internet content server. If your network does not supply an address
automatically and you want to connect using a wired connection then the
address must be set manually. To do this press and hold the Escape logo
at the bottom of the screen and then release. when doing this you will be
asked to enter a passcode which is 2222.

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
After doing this you will be presented with a screen from the operating system where you will be able to
manually switch from an automatically provided ip address to a static one instead.
FIRST SELECT “Ethernet”.
Then you will need to switch “ethernet ip mode” from “dhcp” to “static”
You will then be able to enter and save your ip settings to match your required settings manually like the
example shown below.

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
For connection to the internet using a WiFi connection the wifi network and password need to be
entered that match the available WiFi network. This is done in a similar way to that shown above.
Firstly you will need to ensure that the three WiFi antennas are attached, screwed in fully and angled
for the best possible reception.
To access the WiFi settings press and hold the Escape logo at the bottom of the screen and then
release. When doing this you will be asked to enter a passcode which is 1111.
The following screen will then appear.
By pressing on the “select a network” box, you will be able select the network by which you want to
connect the MARS screen to the internet followed by the WiFi pass code.

© ESCAPE FITNESS LIMITED 2022 | MARS SCREEN-QUICK START GUIDE - REV APRIL 2022
MARS SCREEN.
QUICK START GUIDE.
CUSTOMER SUPPORT.
If your screen doesn’t start within 5 minutes, or you have any other concerns, please call our
oces – [phone] (UK) or [phone] (USA) – quoting the details shown below
1-5. the serial number that can be found after holding down on the Escape logo at the bottom of
the screen and pressing “1111”
YOU WILL BE ASKED THE FOLLOWING WHEN CALLING:
1. CONTACT NAME
2. INSTALLATION ADDRESS
3. CONTACT TELEPHONE NUMBER
4. EMAIL ADDRESS
5. SERIAL NUMBER OF THE UNIT
FULL INSTALLATION INSTRUCTIONS.
FOR YOUR FULL PACK OF INSTALLATION INSTRUCTIONS PLEASE VISIT:
escapefitness.com/user-guides/mars2-screen
4.
STEP. 5
POWERING DOWN.
PLEASE NOTE. Do not simply unplug the power to switch o.
the MARS screen must be shut down in the correct way to avoid
damage. To do this press and hold the black button just above
the rocker switch on the bottom left of the screen until a popup
appears at the top right of the screen, then select shutdown.
When the screen turn completely black then turn the rocker
power switch to the o position.
FOR FURTHER INFORMATION INCLUDING REGULATORY INFORMATION
AND TO REGISTER YOUR PRODUCT TO OBTAIN WARRANTY VISIT.
escape fitness.com/user-guides/mars-screen
WE HOPE YOU ENJOY YOUR MARS SCREEN!