SETTING UP
1. Insert 2 x AA batteries and wait until the
instrument no longer displays 'init'.
2. Press and hold both buttons for 5 seconds.
The display will show 'SEt uP'
3. Connect to the WiFi network called
'ThermaData WiFi Dxxxxxxxxx'
('xxxxxxx' is the serial number on the rear
of your instrument).
4. Once connected, open your web browser
and visit: http://my.thermadatawifi/
5. Enter your WiFi network details and click
“Save Configuration”
6. The instrument will connect to the WiFi
network and confirm it is connected.
7. Connect to the instrument with ThermaData
Studio or the ThermaQ App.
BATTERY CHANGING
You will need a flat-headed screwdriver
(provided in box).
1. Place the instrument display-down on a
solid surface.
2. Unscrew and remove the battery cover.
3. Remove batteries (top one first).
4. Fit new batteries, noting the polarities
marked on the plastic.
5. Replace battery cover, then tighten battery
screw.
6. Dispose of the old batteries appropriately.
If this is the first time the instrument has
been used then it will need setting up in
ThermaData Studio or the ThermaQ App.
If it has previously been used then it will
attempt to reconnect to the WiFi and continue
recording.
WARNING: IPA and other solvents may
cause damage to the case and screen of
this instrument.
Full operating instructions can be found
on the ThermaData Studio Software.
