EUFY T8740 User manual

Anker Innovations Limited.All rights reserved. eufy and the eufy logo are trademarks of Anker
Innovations Limited, registered in the United States and other countries.All other trademarks are
the property of their respective owners.
51005002240 V01
USER MANUAL
Video Doorbell Chime

Table of Contents
What’s in the Box 01
What’s Required for Installation? 01
Installation 02
Replacing the Power Connector 03
Notice 04
Customer Service 07

01 English English 02
INSTALLATION
Step 1. Fix the Power Connector to the Doorbell Chime.
A. Place the Power Connector over the Chime in the direction the arrows
indicate.
B. Align the raised slots of the Power Connector with the notch on the base of
the Doorbell Chime.
C . Rotate clockwise to lock the Power Connector in place.
A B C
Step 2. Plug the Doorbell Chime into an AC power supply at your desired
location.
Step 3. Plug the USB dongle into the USB port on the back of the HomeBase 2.
WHAT’S IN THE BOX
Doorbell Chime
Model:T8740
Power Connector
(Pin type may vary
in different regions)
Doorbell Chime USB
Dongle for HomeBase 2
Model:T8741
WHAT’S REQUIRED FOR
INSTALLATION?
This Doorbell Chime is an accessory exclusive to the eufy Security Video
Doorbell 2K (Battery-Powered).
The USB dongle enables eufy HomeBase 2 to connect to doorbell chimes. One
USB dongle can control up to 4 doorbell chimes.
The USB dongle can only work with HomeBase 2 when a eufy video doorbell is
connected to this HomeBase 2 and the doorbell is pressed.

03 English English 04
2. Install the new Power Connector onto the Doorbell Chime following the same
procedure mentioned at the start of the guide.
NOTICE
This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
Hereby,Anker Innovations Limited declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.For the
declaration of conformity, visit the Web site
https://www.eufylife.com/.
Do not use the Device in the environment at too high or too low temperature, never
expose the Device under strong sunshine or too wet environment.
The suitable temperature for the product and accessories is 0 °C - 45 °C .
RF exposure information:The Maximum Permissible Exposure (MPE) level has been
calculated based on a distance of d=20 cm between the device and the human body.
To maintain compliance with RF exposure requirement, use product that maintain a
20cm distance between the device and human body.
433MHz Frequency Range:433.92MHZ;433MHz Max Output Power:7.303dBm
The following importer is the responsible party (contact for EU matters only)
Importer:Anker Technology (UK) Ltd
Importer Address: Suite B, Fairgate House, 205 Kings Road,Tyseley, Birmingham, B11
2AA, United Kingdom
This product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste,
and should be delivered to an appropriate collection facility for recycling.
Proper disposal and recycling helps protect natural resources, human health
and the environment. For more information on disposal and recycling of this
product, contact your local municipality, disposal service, or the shop where
you bought this product.
Step 4. In the eufySecurity App, go to Doorbell Settings - Indoor Chime.
Follow the onscreen instruction to add the Chime to your existingVideo
Doorbell.
Step 5. You may select the ringtone and adjust the volume level by using the
Music and Volume buttons located on the side of the Doorbell Chime.
There are 8 ringtones and 3 volume levels selectable. Each Chime can play a
different ringtone according to your setting.
REPLACING THE POWER CONNECTOR
1. Press the Lock button and twist the Power Connector counterclockwise at the same
time to remove it from the Doorbell Chime base.

05 English English 06
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of
the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase
the separation between the equipment and receiver. (3) Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements.The
device can be used in xed / mobile exposure condition. The min separation distance
is 20cm.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue,WA 98004-5541
Telephone: [phone]
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement."

CUSTOMER SERVICE
• Warranty
12-month Limited Warranty
• Call Us
United States [phone] Mon-Fri 9AM-5PM (PT)
United Kingdom [phone] Mon-Fri 6AM-11AM (GMT)
Germany [phone] Mon-Fri 6:00-11:00
• Email Us
Customer Support: suppor[email protected]
Anker Innovations Limited
Room 1318-19,Hollywood Plaza,610 Nathan Road,Mongkok,Kowloon,Hong Kong