EUFY IndoorCam Mini User manual
QUICK
START GUIDE
IndoorCam Mini
OVERVIEW
PRODUCT
1
1Lens 5Speaker
2Microphone 6Power input
3SD card slot 7SYNC button
4Status LED
1
2
3
4
7
6
5
Model：T8414
INDOORCAM
POWERING
2
TO EUFY SECURITY APP
ADDING
3
1. Download and install the eufy Security app,then sign up for
an account.
2. Follow on-screen instructions to complete the setup.
Status LED Description
Blinking blue slowly Ready for setup.
Blue Working properly.
Blinking red slowly Disconnected from the Internet.
Blinking red once Motion or sound detected.
Red Someone is watching a live
stream or recording an event.
Purple Initializing system.
Alternating blue and
red
Upgrading firmware.
INDOORCAM
MOUNTING
4
Select a Location
The camera can be placed on a table, shelf, or can be mounted
on a wall or ceiling.
Keep the camera at least 0.7 ft / 20 cm away from walls or
anything that may obstruct the view. Do this to avoid infrared
reection which can have a negative impact on the night vision
performance.
> 20CM > 20CM
Ceiling Mount
1. Place the positioning card against the ceiling and then mark
the points.
2. Drill holes with a 5/16” (8 mm) drill bit.
3. Insert the anchors into the holes, align the holes on the
mounting plate with those in the ceiling, and x the screws with
a Phillips-head screwdriver to fasten the mounting plate to the
ceiling.
Ceiling. Ceiling.
4.Align the grooves with the mounting plate and rotate the
camera clockwise until it clicks into place.
Wall Mount
To mount the camera on a wall, we recommend using a
mounting bracket (not provided) as illustrated below.
ANGLES
SETTING
5
Open the eufy Security app, and set a default angle and a privacy
angle for the camera on Camera Settings > Angle Settings.
Default Angle
The camera will automatically rotate to this angle when turned
on and when motion tracking ends.
Privacy Angle
If Privacy Mode (Camera Settings > Privacy Mode) is turned
on, the camera will be turned off and automatically rotates to
the privacy angle you set. If no angle is set and Privacy Mode is
turned on, the camera will turn 180° from the Default Angle.
NOTICE
6
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment
and receiver. (3) Connect the equipment into an outlet
on a circuit different from that to which the receiver is
connected. (4) Consult the dealer or an experienced radio/
TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure
requirements. The device can be used in xed/mobile
exposure condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made
using shielded cables to maintain compliance with FCC
regulations.
The following importer is the responsible party.
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004
Telephone: 1-800-988-7973
IC Statement
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-
003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
IC RF Statement
When using the product, maintain a distance of 20cm
from the body to ensure compliance with RF exposure
requirements.
Lors de l'utilisation du produit, maintenez une distance de
20 cm du corps an de vous conformer aux exigences en
matière d'exposition RF.
The adapter shall be installed near the equipment and shall
be easily accessible.
Do not use the Device in the environment at too high
or too low temperature, never expose the Device under
strong sunshine or too wet environment.
The suitable temperature for T8414 and accessories is
-20°C-45°C (-4°F - 113°F).When supplying, please place
the device in an environment that has a normal room
temperature and good ventilation.
It is recommended to supply the device in an environment
with a temperature that ranges from 5°C~25°C.
Please ensure to use only the adapter offered by the
manufacturer. Using unauthorized adapter may cause
danger and violate the authorization of the device and the
guarantee article.
This adapter is for indoor use only.
The output voltage/current of the adapter is 5VDC/1A.The
plug is considered as disconnect device of adapter.
Wi-Fi Operating Frequency Range: 2412~2462MHz;
This product is designed and manufactured with high
quality materials and components, which can be
recycled and reused.
Customer Service
Warranty
12-month limited warranty
Call Us
United States
+1 (800) 988 7973 Mon-Fri 9AM-5PM (PT)
United Kingdom
+44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT)
Germany
+49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
Email Us
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road,
Mongkok, Kowloon, Hong Kong
@EufyOfficial @EufyOfficial @EufyOfficial
Table of contents
Other EUFY Digital Camera manuals
