For safe use of your product and to avoid serious injury:
• Perform leak checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and ignition
sources.
• Before each use: Keep stove area clear and free from combustible
materials, gasoline, and other lammable vapors and liquids.
• Do not obstruct the low of combustion and ventilation air to the stove.
• Connect Fuel Regulator (3.1) to the Fuel Input port (1.6) located on the center
of the right side of the stove by threading Coupling clockwise.
• Connect Propane Cylinder (4.1) (sold separately) into Fuel regulator (4.2) by
threading clockwise in the orientation shown in Fig. 4.
6
• To light, depress igniter button (1.7) as shown in Fig. 7. Repeat as necessary.
• If ignition does not occur within 5 seconds, close control valves (1.5) and
wait 5 minutes before repeating the procedure.
Always check that the burners are extinguished before
disconnecting the fuel source. Vapors can ignite and cause
WARNING
serious injury.
Always disconnect fuel cylinder from Regulator after use.
After Use: Turn o open control valves (1.5) (tighten clockwise) to extinguish
lame to each burner.
Cooking: Rotate control valve (1.5) of the lit burner clockwise to decrease
lame setting.
Note: Our advanced Simmer Control technology allows 2 complete rotations
of lame adjustment.
OPERATING INSTRUCTIONS
• Keep burner at arm’s length, away from face, during ignition. Flame can
erupt and lare during ignition.
• Never expose stove to lammable vapors or liquids while lighting the
burner. It can cause an explosion or ire.
• Do not move, lift, or tilt stove with lit burner(s). Flaring may occur.
• Always check that the burners are extinguished before disconnecting the
fuel source. Vapors can ignite and cause serious injury.
WARNING
Lighting the Burners:
CAUTION
• Open either control valve (1.5) counterclockwise until fully opened and gas
low can be heard.
Note: Our advanced Simmer Control technology requires
2 complete rotations to achieve full gas low.
Remove all vessels from cooking surfaces prior
to lighting.
