Eureka Breezeway User manual

Assembly Instructions for the Breezeway:
REV D 4.09
Component List:
1 Screen/Body w/ Hub 1 Tent Bag 1 Pole Bag
4 Poles 1 Stake Bag and Stakes
You can usually assemble this Breezeway alone. However, with first
time set-up or with windy conditions, you will need help.
fig.6
fig.4
fig.2
fig.3
fig.1
fig.5
fig.7
fig.8
1. Unpack the tent bag, pole bag and separate all of the components.
Unroll and unfold the fabric with the Eureka! label up.
3. Assemble all of the shock-corded poles. Check and make sure that
each section is fully seated into the next. See fig.2.
2. Locate the spider hub fitting attached to the center of the roof.
See fig.1.
4. Slide a top pole section onto a spider hub arm. See fig.3.
5. Check and make sure the hub and fabric are aligned.
Then, insert the proper corner ring & pin into the bottom
pole section. See fig.4.
6. Repeat with a second pole onto the opposite hub arm
to form and arch. Lift the arch; attach the remaining two
poles to erect a free standing unit. See fig. 5.
Take down:
• Zip the doors closed.
• Unstake the Breezeway.
• Unclip the fabric from the frame.
• Remove the corner pins from the ends of the poles.
• Remove the poles from the hub, unseat each section and
store in the pole bag.
• Fold the fabric into thirds. Place the pole bag on the fabric
and together, roll them up.
• Pack all components into the tent bag.
7. Attach all of the top pole clips. Attach the bungee cords
to all the corner hooks. Then attach all remaining clips.
See fig.6.
8. Stake down all four corner rings and your
Breezeway is ready. See figs.7 & 8.
www.eurekatent.com
1.800.572.8822
®
YOUR SHELTER IS READY!

LEAVE NO TRACE
Seven General Principles
1. PLAN AHEAD AND PREPARE
2. TRAVEL & CAMP ON DURABLE SURFACES
3. DISPOSE OF WASTE PROPERLY
4. LEAVE WHAT YOU FIND
5. MINIMIZE CAMPFIRE IMPACTS
6. RESPECT WILDLIFE
7. BE COURTEOUS OF OTHER VISITORS
To learn more…
WWW.LNT.ORG
LIMITED WARRANTY FOR ALUMINUM POLE SHELTERS:
Johnson Outdoors Gear LLC's aluminum pole shelter is warranted to the original
purchaser that it is free from major defects in materials or workmanship for the
life of the product, except as qualified below. We are not responsible for normal
wear and tear or for damages caused by shipping, accidents, misuse, alterations,
or improper installations. Additionally, although we manufacture Johnson
Outdoors Gear LLC products with quality fabrics, we are not responsible for the
negative effects of climate, pollution, acts of God, and long or semi-permanent
installations. Because these shelters are temporary structures, it is necessary that
any Johnson Outdoors Gear LLC shelter be installed and maintained according
to the manufacturer’s instructions.
What Johnson Outdoors Gear LLC Will Do:
If after inspection we find that a product failed due to a manufacturing or material
defect, we will repair or replace the product, at our option, without charge.
How to Obtain Warranty Service:
Return the product, freight prepaid, to the Dealer from whom it was purchased; or,
contact our Customer Satisfaction Department for return authorization: toll free
1-800-572-8822. Collect shipments or shipments without return authorization
cannot be accepted. The product registration card packaged with our product
need not be returned for the warranty to be effective and for you to receive
warranty service.
THERE ARE NO OTHER EXPRESS WARRANTIES BEYOND THE TERMS OF THIS
LIMITED WARRANTY. IN NO EVENT SHALL JOHNSON OUTDOORS GEAR LLC
BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
How State Law Relates To This Warranty:
This warranty gives you specific legal rights, and you may have other rights that
vary from state to state.
CAUTION:
Good judgment and common sense must be used for each installation and take
down. Since weather is unpredictable, it is the responsibility of the individual
installing the shelter to determine the proper time and method to install, secure
and dismantle the shelter. Johnson Outdoors Gear LLC shelter products are
manufactured for use as temporary protection from sun and light rain. Evacuate
the shelter in threatening or severe weather.
GUYLINES:
Should winds or storms arise, do not count on staking alone to keep your shelter secure. It’s important
to put in the extra time to guying out. Correctly done, it can save your shelter during exceptional
weather. Attach parachute cord [ not provided ] to the corner hooks and stake it to the ground three or
four feet from the edge of the shelter.
ULTRAVIOLET LIGHT:
Ultraviolet light damage to the shelter fabric is caused by excessive exposure to sunlight. While our
fabrics are UV resistant, any synthetic fabric is susceptible to UV degradation. UV damage will cause
nylon and polyester to become brittle and tear easily. UV damage can be minimized by erecting
shelters on sites with low exposure to direct sunlight.
CLEANING:
• Clean the shelter by setting it up and wiping it down with a mild soap (liquid hand soap) and
lukewarm water solution. Rinse thoroughly and dry completely. Never use detergent, washing
machines or dryers because they can damage the tent’s protective coating and seams. After cleaning,
be sure the shelter is completely dry, especially the heavier, double-stitched areas such as the seams,
before storing or mold and mildew are likely to grow.
• Clean the poles with a cloth and lubricate them with silicone spray. This is especially necessary after
ocean side camping trips to remove salt spray so the poles don’t corrode or stay gritty.
ALTERATIONS OR MODIFICATIONS:
DO NOT misuse, modify or alter this product in any way from its condition at the time of sale. Alteration,
modification or any use of this product contrary to the accompanying written instructions shall void the
warranty. Moreover, any misuse, alteration or modification of the product shall absolve Johnson
Outdoors Gear LLC. of any liability for property damages or injuries sustained as a result of such
misuse, modification or alteration.
WARNING:
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS SHELTER FABRIC.
This shelter meets the flammability requirements of CPAI-84. The fabric may burn if left in
continuous contact with any flame source. The application of any foreign substance to the
fabric may render the flame-resistant properties ineffective.
REV D FEB.09
JOHNSON OUTDOORS GEAR LLC